Prestige 642 PPPoE Modem

2.2.4 Connecting the Console Port

For the initial configuration of your Prestige, you need to use terminal emulator software on a computer and connect it to the Prestige through the console port. Connect the 9-pin end of the console cable (9-pin to 25- pin console cable supplied) to the console port of the Prestige and the 25-pin end to a serial port (COM1, COM2 or other COM port) of your computer. You can use an extension RS-232 cable if the enclosed one is too short.

2.3Additional Installation Requirements

In addition to the contents of your package, there are other hardware and software requirements you need before you can install and use your Prestige. These requirements include:

zA computer with Ethernet 10Base-T/100Base-T NIC.

zA computer equipped with communications software (for example, Hyper Terminal in Win98) configured to the following parameters:

¾VT100 terminal emulation.

¾9600 Baud rate.

¾No parity, 8 Data bits, 1 Stop bit.

¾Flow Control set to None

After the Prestige has been successfully connected to your network, you can make future changes to the configuration through the telnet application.

2.4Connecting a POTS Splitter

This is for the Prestige following the Full Rate (G.dmt) standard only. One major difference between ADSL and dial-up modems is the optional telephone splitter. This device keeps the telephone and ADSL signals separated, giving them the capability to provide simultaneous Internet access and telephone service on the same line. Splitters also eliminate the destructive interference conditions caused by telephone sets. The purchase of a POTS splitter is optional.

Noise generated from a telephone in the same frequency range as the ADSL signal can be disruptive to the ADSL signal. In addition the impedance of a telephone when off-hook may be so low that it shunts the strength of the ADSL signal. A POTS splitter will filter the telephone signals before combining the ADSL and telephone signals transmitted and received. The issues of noise and impedance are eliminated with a single POTS splitter installation.

A telephone splitter is easy to install as shown in the following figure.

Hardware Installation & Initial Setup

2-3