Prestige 642 PPPoE Modem

Step 3. Press [ENTER] when prompted for a username.

Step 4. Enter your password as requested (the default is 1234). Step 5. Enter “bin” to set transfer mode to binary.

Step 6. Find the “rom” file (on your computer) that you want to restore to your Prestige.

Step 7. Use “put” to transfer files from the Prestige to the computer, for example, “put config.rom rom-0” transfers the configuration file on the Prestige to your computer and renames it “config.rom”. See earlier in this chapter for more information on filename conventions.

Step 8. Enter “quit” to exit the ftp prompt.

ftp> put config.rom rom-0 200 Port command okay

150Opening data connection for STOR rom-0

226File received OK

221Goodbye for writing flash

ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec. ftp>quit

Figure 5-4 FTP Session Example

Step 9. Enter “atgo” to restart the Prestige.

5.3.2 Restore Via Console Port

This chapter has examples for backup configuration, restore configuration, and upload firmware using the HyperTerminal program. Other serial communications programs should be similar.

Step 1. Enter the Command Line Interface by following the instructions in the Command Line Interface chapter.

Step 2. Enter “r s”. Step 3. Enter “atlc”.

Step 4. Run the HyperTerminal program. Click Transfer, then Send File as shown in the following screen.

Firmware and Configuration File Maintenance

5-7