Prestige 642 PPPoE Modem
Wall | Modem | ||||
|
|
|
| ||
|
|
|
| ||
Jack |
|
| POTS Splitter |
| |
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Line | Phone |
Step 1. Connect the side labeled “Phone” to your telephone.
Step 2. Connect the side labeled “Modem” to your Prestige.
Step 3. Connect the side labeled “Line” to the telephone wall jack.
2.5Default Settings
Your Prestige is shipped with the following default settings:
¾VPI: 8, VCI: 35
¾WAN interface: PPPoE LLC mode
¾Console port speed: 9600 bps
¾DHCP: Server
¾Password: “1234”
Depending on your region, the default password and VPI/VCI may differ.
2.6Turning On the Prestige
At this point, you should have connected the console port, the ADSL line, the Ethernet port and the power port to the appropriate devices or lines. Execute the terminal emulation program if you plan to configure the Prestige with the Command Line Interface. Turn the power switch (located on the back of your Prestige) from OFF to ON to turn on your Prestige.
•Proceed to the Web Configurator chapter if you want to configure the Prestige using the web configurator. This is the most
•Proceed to the Command Line Interface chapter if you want to configure the Prestige using the Command Line Interface.
Hardware Installation & Initial Setup |