ZyXEL Communications WAP3205 Login, Apply, Ignore, Start > Run, Client Mode, Client Mode, Maintenance > Sys OP Mode

Chapter 4 Client Mode

4.4 Setting your WAP3205 to Client Mode

1Connect your computer to the LAN port of the WAP3205.

2The default IP address of the WAP3205 is “192.168.1.2”. In this case, your computer must have an IP address in the range between “192.168.1.3” and “192.168.1.254”.

3Click Start > Run on your computer in Windows. Type “cmd” in the dialog box. Enter “ipconfig” to show your computer’s IP address. If your computer’s IP address is not in the correct range then see Appendix C on page 141 for information on changing your computer’s IP address.

4After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and type “http://192.168.1.2” as the web address in your web browser.

5Enter “1234” (default) as the password and click Login.

6Type a new password and retype it to confirm, then click Apply. Otherwise, click Ignore.

7To set your WAP3205 to Client Mode, on the left of the screen, click Maintenance > Sys OP Mode and select Client Mode.

Figure 10 Changing to Client mode

Note: You have to log in to the Web Configurator again when you change modes. As soon as you do, your WAP3205 is already in Client mode.

Note: The client mode IP address is always the same as the access point mode IP address. If you changed the IP address of your WAP3205 while in access point mode, use this IP address in client mode.

4.5 Client Mode Status Screen

Click to open the status screen.

24
	WAP3205 User’s Guide