Chapter 10 Wireless LAN

10.10 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this screen, click Network > Wireless LAN > WPS Station tab.

Note: After you click Push Button on this screen, you have to press a similar button in the wireless station utility within 2 minutes. To add the second wireless station, you have to press these buttons on both device and the wireless station again after the first 2 minutes.

Figure 68 Network > Wireless LAN > WPS Station

The following table describes the labels in this screen.

Table 38 Network > Wireless LAN > WPS Station

LABEL

DESCRIPTION

Push Button

Use this button when you use the PBC (Push Button Configuration) method to

 

configure wireless stations’s wireless settings. See Section 8.3.1 on page 60.

 

Click this to start WPS-aware wireless station scanning and the wireless security

 

information synchronization.

 

 

Or input station’s

Use this button when you use the PIN Configuration method to configure

PIN number

wireless station’s wireless settings. See Section 8.3.2 on page 61.

 

Type the same PIN number generated in the wireless station’s utility. Then click

 

Start to associate to each other and perform the wireless security information

 

synchronization.

 

 

10.11 Scheduling Screen

Use this screen to set the times your wireless LAN is turned on and off. Wireless LAN scheduling is disabled by default. The wireless LAN can be scheduled to turn on or off on certain days and at certain times. To open this screen, click Network > Wireless LAN > Scheduling tab.

 

97

WAP3205 User’s Guide