Chapter 25 Device HA

Table 126 device-ha ap-mode Commands (continued)

COMMAND

DESCRIPTION

[no] device-ha ap-mode interface_name

Sets the management IP address for an interface.

manage-ipip subnet_mask

 

[no] device-ha ap-mode interface_name

Has device HA monitor the status of an interface’s connection.

activate

 

[no] device-ha ap-mode master sync

This is for a master ZyWALL. It specifies the password to require from

authentication password password

synchronizing backup ZyWALLs. Every router in the virtual router must use

 

the same password. The no command sets the password setting to blank

 

(which means no backups can synchronize with this master).

 

password: Use 4-63 alphanumeric characters, underscores (_), dashes (-),

 

and #%^*={}:,.~ characters.

[no] device-ha ap-mode backup sync

Sets the password the backup ZyWALL uses when synchronizing with the

authentication password password

master. The no command sets the password setting to blank (which means

 

this backup ZyWALL cannot synchronize with the master).

 

password: Use 4-63 alphanumeric characters, underscores (_), dashes (-),

 

and #%^*={}:,.~ characters.

[no] device-ha ap-mode backup sync

Turns on automatic synchronization according to the interval you specify in

auto

device-ha ap-mode backup sync interval. The first synchronization

 

begins after the specified interval (not immediately).

 

 

[no] device-ha ap-mode backup sync

When you use automatic synchronization, this sets how often (in minutes)

interval <1..1440>

the ZyWALL synchronizes with the master.

[no] device-ha ap-mode backup sync

Sets the address of the master ZyWALL with which this backup ZyWALL is

from master_address port port

to synchronize.

 

master_address: The master ZyWALL’s IP address or fully-qualified domain

 

name (FQDN).

 

port: The master ZyWALL’s FTP port number.

 

 

device-ha ap-mode backup sync now

Synchronize now.

show device-ha ap-mode interfaces

Displays the device HA AP mode interface settings and status.

show device-ha ap-mode next-sync-time

Displays the next time and date (in hh:mm yyyy-mm-dd format) the

 

ZyWALL will synchronize with the master.

show device-ha ap-mode status

Displays the ZyWALL’s key device HA settings.

show device-ha ap-mode master sync

Displays the master ZyWALL’s synchronization settings.

show device-ha ap-mode backup sync

Displays the backup ZyWALL’s synchronization settings.

show device-ha ap-mode backup sync

Displays the backup ZyWALL’s current synchronization status.

status

 

show device-ha ap-mode backup sync

Displays the backup ZyWALL’s synchronization settings.

summary

 

show device-ha ap-mode forwarding-port

If you apply Device HA on a bridge interface on a backup ZyWALL, you can

interface_name

use this command to see which port in the bridge interface is chosen to

 

receive VRRP packets used to monitor if the master ZyWALL goes down.

 

interface_name: This is a bridge interface, For example, brx.

 

 

224

 

ZyWALL (ZLD) CLI Reference Guide