Husqvarna CZE 4818 manual Operation, Controls

Page 15

	OPERATION
CONTROLS
		3	3
		3
	1
5
	7		8
	7		9
			9
4
10			CZ-5
10
	CZ-3
			2
	6
	CZ-10		CZ-6
	CZ-10

FIGURE 3

1.PTO SWITCH – Used to engage or disengage the deck blades.

2.FOOT PEDAL – Used to raise, lower and select various cutting heights of the deck.

3.CONTROL LEVERS – Sets the speed of the mower in both forward and reverse directions and turns the mower.

4.CHOKE CONTROL – Used when starting a cold engine.

5.THROTTLE CONTROL – Used to control Engine Speed.

6.IZT (Integraded Zeroturn Transaxle) BYPASS LINKAGES – Bypasses IZT’s for pushing or pulling mower.

7.IGNITION SWITCH – Used to start or stop the engine.

8.PARKING BRAKE LEVER – Engages and disengages the park brakes.

9.TENSION RELIEF LEVER – Used to release the belt tension on the deck belt for ease in removing or replacing the belt.

10.HOUR METER – Indicates hours of operation.

15

Image 15

Contents CZE Husqvarna. All Rights Reserved Beatrice, NE Contents Symbols and Decals Safety Instructions Safety InstructionsGeneral Use Personal protective equipment Do as follows Driving on SlopesChildren 8011-563 Important Information TransportSpecifications Before Removing the Mower from the Skid AssemblyTools Required for Assembly To Remove the Mower from CrateControl Lever ARM HEX Bolts Neutral Slot Check the Tire Pressure ChecklistControls OperationEngine HOW to USE Your MowerOperation Deck BladesTo Adjust the Deck Cutting Height See Fig To Adjust ANTI-SCALP Roll ERS See FigureTo Operate on Hills To Transport See Fig ADD Gasoline Before Starting the EngineTo Start Engine See Fig Check Engine OIL LevelMowing Tips Customer Responsibilities General RecommendationsBefore Each USE Tires Lubrication ChartOperator Presence System Blade CareTo Sharpen Blade See Fig BatteryEngine Clean AIR ScreenClean AIR INTAKE/COOLING Areas BeltsSpark Plugs CleaningAIR Filter Engine OIL FilterService and Adjustment MowerTo Level Deck To Replace Deck Belt FRONT-TO-BACK Adjustment See FigIZT Belt Removal To Replace IZT Integraded Zeroturn Transaxle Belt SeeTo Remove Wheels for RE- Pair To Adjust the Seat See FigTo Adjust Control Levers See Fig To Start AN Engine with a Weak BatteryTo Adjust Park Brake Replacing Battery See FigTracking Adjustment Engine OIL BatteryStorage Fuel SystemOther CylindersProblem Cause Correction Troubleshooting PointsTo run when Wiring Schematic ´z+H56¶6M¨ Page 2003W33 114 02