Husqvarna CZE 4818 manual Tracking Adjustment

Page 32

SERVICE AND ADJUSTMENT

1/4" gap should exist between the "U" shaped brake arm and the inside of the brake bolt head. See Fig. 20.

 

HEAD OF

 

BRAKE BOLT

"U" SHAPED

BRAKE CABLE

BRAKE ARM

 

 

CZ-24

FIGURE 20

The 1/4" gap can be adjusted with the brake swivel (located under the seat), pull pin and rotate swivel one turn counter-clockwise to increase gap or clockwise to decrease the gap until the 1/4" gap is attained. See Fig. 21.

SWIVEL

BRAKE CABLE

HAIR PIN

TRACKING ADJUSTMENT

IMPORTANT: DO NOT adjust the drive cables in an attempt to resolve tracking issues. Cables are set at the factory and should only be adjusted by authorized service retailers.

If the mower is not tracking straight, check the air pressure in both rear tires. Recommended air pressure is 15 psi. If the unit will not track straight, follow the steps below. Tracking must be checked on a flat and level concrete or blacktop surface.

Mower is tracking to the right. In- crease the air pressure 2-3 psi in the right rear tire or decrease the air pres- sure 2/3 psi in the left rear tire.

Mower is tracking to the left. Increase the air pressure 2-3 psi in the left rear tire or decrease the air pressure 2/3 psi in the right rear tire.

Recheck tracking and keep making adjustments with the tire pressure until the unit tracks straight. DO NOT exceed maximum recommended tire pressure 24 psi.

Record the tire pressure for future reference.

CZ-25

FIGURE 21

NOTE: After making any adjustments, check to make sure the brake disengages the brake sprockets, when the brake is in the "OFF" position.

32

Image 32
Contents CZE Husqvarna. All Rights Reserved Beatrice, NE Contents Symbols and Decals General Use Safety InstructionsSafety Instructions Personal protective equipment Driving on Slopes Do as followsChildren 8011-563 Transport Important InformationSpecifications Assembly Tools Required for AssemblyTo Remove the Mower from Crate Before Removing the Mower from the SkidControl Lever ARM HEX Bolts Neutral Slot Checklist Check the Tire PressureOperation ControlsHOW to USE Your Mower OperationDeck Blades EngineTo Adjust the Deck Cutting Height See Fig To Operate on Hills To Adjust ANTI-SCALP RollERS See Figure To Transport See Fig Before Starting the Engine To Start Engine See FigCheck Engine OIL Level ADD GasolineMowing Tips Before Each USE Customer ResponsibilitiesGeneral Recommendations Lubrication Chart Operator Presence SystemBlade Care TiresBattery To Sharpen Blade See FigClean AIR Screen Clean AIR INTAKE/COOLING AreasBelts EngineCleaning AIR FilterEngine OIL Filter Spark PlugsTo Level Deck Service and AdjustmentMower FRONT-TO-BACK Adjustment See Fig To Replace Deck BeltTo Replace IZT Integraded Zeroturn Transaxle Belt See IZT Belt RemovalTo Adjust the Seat See Fig To Adjust Control Levers See FigTo Start AN Engine with a Weak Battery To Remove Wheels for RE- PairReplacing Battery See Fig To Adjust Park BrakeTracking Adjustment Battery StorageFuel System Engine OILCylinders OtherTroubleshooting Points Problem Cause CorrectionTo run when Wiring Schematic ´z+H56¶6M¨ Page 114 02 2003W33