Husqvarna CZE 4818 manual Driving on Slopes, Do as follows

Page 7

SAFETY INSTRUCTIONS

Driving on Slopes

Driving on slopes is one of the operations where the risk is greatest that the driver will lose control or the machine will tip over, which can result in serious injury or death. All slopes require extra caution. If you cannot reverse up a slope or if you feel unsure, do not mow the slope.

Do as follows

Remove obstacles such as stones, tree branches, etc.

Mow up and down, not side-to-side.

Never drive the rider on terrain that slopes more than 10°.

Avoid starting or stopping on a slope. If the tires begin to slip, shut down the blades and drive slowly down the slope.

Always drive evenly and slowly on slopes.

Make no sudden changes in speed or direction.

Avoid unnecessary turns on slopes, and if it proves necessary, turn slowly and gradually downward, if possible.

Watch out for and avoid driving over furrows, holes, and bumps. On uneven terrain, the machine can tip more easily. Long grass can hide obstacles.

Drive slowly. Use small movements of the steering controls.

Be extra cautious with any additional equipment, which can alter the machine’s stability.

Do not mow near verges, ditches, or banks. The machine can suddenly spin around if a wheel goes over the edge of a drop or ditch, or if an edge gives way.

Do not mow wet grass. It is slippery, and the tires can lose their grip, so that the machine slides.

Try not to stabilize the machine by putting a foot on the ground.

When cleaning the chassis, the machine may never be driven near verges or ditches.

Mow up and down, not side-to-side

8003-004

 

 

 

 

 

Be extra cautious when driving on slopes

8011-519

 

7

Image 7
Contents CZE Husqvarna. All Rights Reserved Beatrice, NE Contents Symbols and Decals Safety Instructions Safety InstructionsGeneral Use Personal protective equipment Do as follows Driving on SlopesChildren 8011-563 Important Information TransportSpecifications Before Removing the Mower from the Skid AssemblyTools Required for Assembly To Remove the Mower from CrateControl Lever ARM HEX Bolts Neutral Slot Check the Tire Pressure ChecklistControls OperationEngine HOW to USE Your MowerOperation Deck BladesTo Adjust the Deck Cutting Height See Fig ERS See Figure To Adjust ANTI-SCALP RollTo Operate on Hills To Transport See Fig ADD Gasoline Before Starting the EngineTo Start Engine See Fig Check Engine OIL LevelMowing Tips General Recommendations Customer ResponsibilitiesBefore Each USE Tires Lubrication ChartOperator Presence System Blade CareTo Sharpen Blade See Fig BatteryEngine Clean AIR ScreenClean AIR INTAKE/COOLING Areas BeltsSpark Plugs CleaningAIR Filter Engine OIL FilterMower Service and AdjustmentTo Level Deck To Replace Deck Belt FRONT-TO-BACK Adjustment See FigIZT Belt Removal To Replace IZT Integraded Zeroturn Transaxle Belt SeeTo Remove Wheels for RE- Pair To Adjust the Seat See FigTo Adjust Control Levers See Fig To Start AN Engine with a Weak BatteryTo Adjust Park Brake Replacing Battery See FigTracking Adjustment Engine OIL BatteryStorage Fuel SystemOther CylindersProblem Cause Correction Troubleshooting PointsTo run when Wiring Schematic ´z+H56¶6M¨ Page 2003W33 114 02