Husqvarna CZE 4818 manual Service and Adjustment, Mower, To Level Deck

Page 27

SERVICE AND ADJUSTMENT

WARNING

BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

Set park brake to engaged position.

Place PTO switch in the disen- gaged position (pressed down).

Turn ignition key "OFF" and re- move the key.

Make sure the blades and all moving parts have completely stopped.

Disconnect spark plug wire from spark plug and place the wire where it cannot come in contact with the plug.

the front and rear lift linkages (be sure to tighten equal amounts).

To lower one side of the deck, reverse previous step.

Recheck measurements after adjust- ment.

A A

CZ-16

FIGURE 13

MOWER

TO LEVEL DECK

HEX NUT

Adjust the deck while the mower is on a level surface. Make sure the tires are inflated to the correct pressure (see “SPECIFICATIONS” section in this manual). If tires are under or over inflated, you can not properly adjust your deck.

NOTE: It may be easier to adjust the front lift linkages by removing the floor pan before any adjustments are made

SIDE-TO-SIDE ADJUSTMENT (See Figs. 13 and 14)

FRONT LIFT

LINKAGE

FIGURE 14

CZ-17

Raise the deck into the highest cutting position (4 1/2")

Measure height from the bottom edge of the deck to the ground at both front corners. Distance “A” at both corners should be the same.

If adjustment is necessary, make adjust- ment to one side the deck only

To raise one side of the deck, using a 9/ 16" wrench, tighten the hex nuts on both

REAR LIFT

LINKAGE

HEX NUT

CZ-18

FIGURE 14A

27

Image 27
Contents CZE Husqvarna. All Rights Reserved Beatrice, NE Contents Symbols and Decals Safety Instructions Safety InstructionsGeneral Use Personal protective equipment Do as follows Driving on SlopesChildren 8011-563 Important Information TransportSpecifications Before Removing the Mower from the Skid AssemblyTools Required for Assembly To Remove the Mower from CrateControl Lever ARM HEX Bolts Neutral Slot Check the Tire Pressure ChecklistControls OperationEngine HOW to USE Your MowerOperation Deck BladesTo Adjust the Deck Cutting Height See Fig To Adjust ANTI-SCALP Roll ERS See FigureTo Operate on Hills To Transport See Fig ADD Gasoline Before Starting the EngineTo Start Engine See Fig Check Engine OIL LevelMowing Tips Customer Responsibilities General RecommendationsBefore Each USE Tires Lubrication ChartOperator Presence System Blade CareTo Sharpen Blade See Fig BatteryEngine Clean AIR ScreenClean AIR INTAKE/COOLING Areas BeltsSpark Plugs CleaningAIR Filter Engine OIL FilterService and Adjustment MowerTo Level Deck To Replace Deck Belt FRONT-TO-BACK Adjustment See FigIZT Belt Removal To Replace IZT Integraded Zeroturn Transaxle Belt SeeTo Remove Wheels for RE- Pair To Adjust the Seat See FigTo Adjust Control Levers See Fig To Start AN Engine with a Weak BatteryTo Adjust Park Brake Replacing Battery See FigTracking Adjustment Engine OIL BatteryStorage Fuel SystemOther CylindersProblem Cause Correction Troubleshooting PointsTo run when Wiring Schematic ´z+H56¶6M¨ Page 2003W33 114 02