INSTALLATION
Boundary wire
For a successful installation the placement of the boundary wire should be planned carefully. Planning is simplified if you make a sketch of the working area, including all obstacles. Draw how the boundary wire should be routed on the sketch.
The boundary wire should be laid so it:
•Forms a loop around the working area for the Auto Mower. Only Husqvarna boundary wire ought to be used. This is tinned and has a high quality insulation to withstand the dampness in the ground.
•Is a maximum of 500 metres long.
•Maintains a maximum distance of 35 metres from Auto Mower in the entire working area.
•Does not lie on a sharp incline. The Auto Mower may find it difficult to reverse back, especially in damp weather conditions, when there is a large risk of skidding.
Include the possibility in the planning that adjustments may need to be made to the loop. In doing so remem- ber:
•Leave a few extra metres of wire at the beginning and end, close to the charging station.
•Place a few extra metres of wire about every 30
metres around the entire loop.
All extra wire should be laid in tight, parallel loops If staples are used, the parallel loops should be placed under the same staple.
IMPORTANT INFORMATION
Extra wire must not be placed in coils outside the boundary wire. This can disrupt the Auto Mower.