Husqvarna Auto Mower manual Timer override

Page 30

MENU FUNCTIONS

Day timer (2-2)

It is possible to set two different start and stop times for each day. Enter the required time in hours and min- utes.

Reset all timers (2-2-1)

To delete all set times: Select the function and press YES when the cursor is on ”Yes”.

Start time 1 (2-2-2)

Stop time 1 (2-2-3)

Start time 2 (2-2-4)

Stop time 2 (2-2-5)

Timer override

Day timer

Weekend timer

Week timer

2-2

Reset all timers

Start time 1

Stop time 1

Start time 2

Stop time 2

2-2-

Weekend timer (2-3)

Reset all timers (2-3-1)

To delete all set times: Select the function and press YES when the cursor is on ”Yes”.

Start time 1 (2-3-2)

Stop time 1 (2-3-3)

Start time 2 (2-3-4)

Stop time 2 (2-3-5)

Copy from day timer (2-3-6)

Press YES when asked ”Copy?” to transfer all times set in the day timer.

Timer override

Day timer

Weekend timer

Week timer

2-3

Reset all timers

Start time 1

Stop time 1

Start time 2

Stop time 2

Copy from day timer

2-3-

Week Timer (2-4)

Use the YES button to select the days you would like the Auto Mower to mow.

Mon (2-4-1)

Tue (2-4-2)

Wed (2-4-3)

Thu (2-4-4)

Fri (2-4-5)

Sat (2-4-6)

Sun (2-4-7)

Run all (2-4-8)

Move the cursor to ”Run all” and press YES. Then press YES again to the question ”All ON”.

Timer override

Day timer

Weekend timer

Week timer

2-4

Mon

Tue

Wed

Thu

Fri

Sat

Sun

Run all

2-4-

English-31

Image 30
Contents Auto Mower Auto Mower Helpdesk Introduction IntroductionCongratulations Symbols SymbolsSymbols on the Auto Mower Symbols in the Operator’s Manual Xxxxxx xxx xxxx xxxxxxx xxx xxxx xxxx xxxxxSafety Instructions Safety InstructionsUse Maintenance TransportPresentation PresentationFunction Auto Mower Working methodEnglish-11 Capacity Movement patternInstallation InstallationPreparations Auto Mower, what is what? Numbers in the picture corresponds toPlanning the installation Charging stationLength of the low voltage cable must not be changed English-16 English-17 Boundary wire 10 cm Minimise Placing the charging station Charging the battery Laying out the boundary wireConnecting the boundary wire English-24 Checking the installation Linking the Auto Mower to the charging stationControl Panel Control panelShortcuts ProgramMain switch SelectNumbers Menu Functions Menu functionsMain menu Commands TimerTimer override Drive past wire InstallationCharge exit settings Garden shapeDrive past wire Garden shape Check loop Charge exit settings Settings PIN code Sounds Significance Starting Charging Security Sounds User info level Use Charging a discharged batteryUSE Starting the Auto MowerRestart Using the timerStopping the Auto Mower Turn off Auto MowerAdjusting the cutting height Battery MaintenanceMaintenance Winter StorageCleaning Underframe and blade discBody Replacing the blade units Trouble Shooting Trouble shootingFault messages Empty battery Fault message Cause Action OutsideLow battery voltage Wrong PIN codeTrouble Shooting Guide Technical Data Technical DataEU Declaration of Conformity EU declaration of conformityEU Declaration of Conformity only applies to Europe 114 01 2003W23Also See