Husqvarna Auto Mower manual Trouble Shooting, Trouble shooting, Fault messages

TROUBLE SHOOTING

Trouble shooting

Fault messages

A number of fault messages are listed below that can be shown on the display. If another message than those listed is shown, contact your dealer.

Fault message	Cause	Action
Left wheel motor	Grass or other object may have	Check the drive wheel and remove
blocked	become wrapped around the drive	the grass or other object.
	wheel.
Right wheel motor	Grass or other object may have	Check the drive wheel and remove
blocked	become wrapped around the drive	the grass or other object.
	wheel.
Blade disc blocked	Grass or another object may have	Check the blade disc and remove the
	become wrapped around the blade	grass or other object.
	disc.
No loop signal	Wrong PIN code has been stated.	State the correct PIN code.
	The transformer is not connected to	Check the wall socket connection and
	the mains supply or its miniature cir-	whether the miniature circuit-breaker
	cuit-breaker has tripped.	has tripped.
		Reset the miniature circuit-breaker by
		removing the transformer’s power
		cord from the wall socket, wait 10
		seconds and then reconnect the
		power cord in the wall socket again.
	Boundary wire broken.	Check the signal given by the LED on
		the charging station. If it flashes the
		loop is damaged. Repair the broken
		cable using Husqvarna’s waterproof
		connector, part number 535 13 37-01.
	If this occurs in isolated areas it may	Try to move the boundary wire.
	be due to interference from metallic
	objects (perimeter fence, reinforce-
	ment bar) or buried cables in the
	vicinity.
	If it occurs in the vicinity of an ”island”	Check that the boundary wire has
	it may be due to the boundary wire be	been routed correctly.
	routed in the wrong direction around
	”island” and thereby switching off the
	signal.
Trapped	Auto Mower has become caught in	Free the Auto Mower and rectify the
	something.	reason for it becoming trapped.

English-46