Husqvarna Auto Mower manual Placing the charging station

Page 20

INSTALLATION

•In order for the loop system to work well, the wires in passages where the Auto Mower is to run through must not lie too close together.

A passage should be at least 2 metres wide so the Auto Mower can ﬁnd it and make its way through it. The minimum spacing between the wires in a pas- sage is 130 cm.

The transition between a large area and a passage should be, if possible, designed like a ”funnel”, with rounded corners, to make it easier for the Auto Mower to enter the passage.

Secondary

area

Main area

2m

3012-232

C. Placing the charging station

1.Place the charging station according to your plan.

2.Connect the low voltage cable to the charging sta- tion.

Only Husqvarna original cable and transformer may be used.

3012-263

3.Connect the low voltage cable to the transformer.

The connectors may be a slightly difﬁcult to con- nect, as they are moisture-proof.

3012-262

4.Connect the transformer’s power cord to a 230V wall socket. It is preferable to use an earth-fault breaker as recommended.

English-21

Image 20

Contents Auto Mower Auto Mower Helpdesk Congratulations IntroductionIntroduction Symbols on the Auto Mower SymbolsSymbols Symbols in the Operator’s Manual Xxxxxx xxx xxxx xxxxxxx xxx xxxx xxxx xxxxxUse Safety InstructionsSafety Instructions Maintenance TransportPresentation PresentationFunction Auto Mower Working methodEnglish-11 Capacity Movement patternPreparations InstallationInstallation Auto Mower, what is what? Numbers in the picture corresponds toLength of the low voltage cable must not be changed Planning the installationCharging station English-16 English-17 Boundary wire 10 cm Minimise Placing the charging station Charging the battery Laying out the boundary wireConnecting the boundary wire English-24 Checking the installation Linking the Auto Mower to the charging stationControl Panel Control panelShortcuts ProgramNumbers Main switchSelect Main menu Menu FunctionsMenu functions Commands TimerTimer override Installation Charge exit settingsDrive past wire Garden shapeDrive past wire Garden shape Check loop Charge exit settings Settings PIN code Sounds Signiﬁcance Starting Charging Security Sounds User info level Charging a discharged battery USEUse Starting the Auto MowerUsing the timer Stopping the Auto MowerRestart Turn off Auto MowerAdjusting the cutting height Maintenance MaintenanceBattery Winter StorageBody CleaningUnderframe and blade disc Replacing the blade units Fault messages Trouble ShootingTrouble shooting Fault message Cause Action Outside Low battery voltageEmpty battery Wrong PIN codeTrouble Shooting Guide Technical Data Technical DataEU Declaration of Conformity only applies to Europe EU Declaration of ConformityEU declaration of conformity 114 01 2003W23Also See