Husqvarna Auto Mower manual Replacing the blade units

Page 44

MAINTENANCE

Replacing the blade units

WARNING

Always use original blade units when replacing.

Only replacing the blade and reusing the screw and washer, can result in the screw wearing during mowing and shearing off. The blade can then be thrown causing serious injury.

There are three blade units on the blade disc. Each unit consists of a screw, a blade and a lock washer.

Always replace all three blade units at the same time, to obtain a balanced mowing system.

1.Set the main switch to the OFF position.

2.Wear protective gloves.

3.Turn the Auto Mower upside down.

4.Rotate the skid plate so that its holes align over the blade unit screws.

5.Unscrew the blade unit.

Use a straight slot or cross-tip screwdriver.

6.Pry apart the skid plate and blade disc a little and remove the blade unit.

7.Fit the new balde unit.

3012-259

OFF

3012-288

3012-272

3012-260

English-45

Image 44

Contents Auto Mower Auto Mower Helpdesk Congratulations IntroductionIntroduction Symbols on the Auto Mower SymbolsSymbols Symbols in the Operator’s Manual Xxxxxx xxx xxxx xxxxxxx xxx xxxx xxxx xxxxxUse Safety InstructionsSafety Instructions Maintenance TransportPresentation PresentationFunction Auto Mower Working methodEnglish-11 Capacity Movement patternPreparations InstallationInstallation Auto Mower, what is what? Numbers in the picture corresponds toLength of the low voltage cable must not be changed Planning the installationCharging station English-16 English-17 Boundary wire 10 cm Minimise Placing the charging station Charging the battery Laying out the boundary wireConnecting the boundary wire English-24 Checking the installation Linking the Auto Mower to the charging stationControl Panel Control panelShortcuts ProgramNumbers Main switchSelect Main menu Menu FunctionsMenu functions Commands TimerTimer override Installation Charge exit settingsDrive past wire Garden shapeDrive past wire Garden shape Check loop Charge exit settings Settings PIN code Sounds Signiﬁcance Starting Charging Security Sounds User info level Charging a discharged battery USEUse Starting the Auto MowerUsing the timer Stopping the Auto MowerRestart Turn off Auto MowerAdjusting the cutting height Maintenance MaintenanceBattery Winter StorageBody CleaningUnderframe and blade disc Replacing the blade units Fault messages Trouble ShootingTrouble shooting Fault message Cause Action Outside Low battery voltageEmpty battery Wrong PIN codeTrouble Shooting Guide Technical Data Technical DataEU Declaration of Conformity only applies to Europe EU Declaration of ConformityEU declaration of conformity 114 01 2003W23Also See