Husqvarna SMB 70, SMB 70 E manual Saw Carriage Adjustment

INSTALLATION

Saw Carriage Adjustment

The saw carriage is aligned on the rails by fitting its lower guide wheels and rail guards. The lower guide bearings have the task of preventing the saw carriage from tilting and the rail guards keep the rails and the saw carriage’s wheels free from dirt and the like. Assembled on the saw carriage are:

•Two lower guide wheels

•Four rail guards.

Assembly is done as follows:

1.Fix the guide wheel’s bracket in place with a screw. Place a 0.2 mm feeler gauge between the bearing and rail.

2.Press the bearing against the rail and tighten the bearing bracket screw. Tightening torque: 40-50 Nm. Now remove the feeler gauge.

3.Carry out 1-2 above for the remaining guide wheels.

4.Position the four rail guards above the wheel.

5.Adjust and screw into place the frame (25) and guide FIG. 26 A.

FIG. 23

FIG. 24

0,2 mm

FIG. 25

FIG. 26

18 –English