Husqvarna SMB 70, SMB 70 E manual Starting the Petrol Engine, Starting the Electric Motor

Page 28

USE

!WARNING!

Check during sawing that the bandsaw blade does not hit the folding stops or log lock.

!WARNING!

The saw carriage must not be moved backwards while the bandsaw blade is in motion. Otherwise the bandsaw can jump off and cause personal injury.

Starting the Petrol Engine

1. Start the engine. See page 24.

Starting the Electric Motor

1. Start the electric motor. See page 25.

Sawing

2.Move the saw carriage forwards and cut off the sapwood.

3.Remove the sapwood.

4.Loosen the log, turn it 180°, lower the height adjuster (B), and secure the log.

5.Set the required cutting height using the height adjustment crank (B). This determines the width of the board.

6.Set the band guide as close as possible to the log without the log and band guide touching each other. Lock the band guide using its lever.

7.Cut off the sapwood on the other side. See p 2 and 3.

FIG. 49

FIG. 50

28 – English

Image 28

Contents SMB SMB 70 E Table of Contents Introduction IntroductionKEY to Symbols SymbolsSafety Regulations Safety RegulationsPersonal Protective Equipment One-man Sawmill Safety Equipment Fuel SafetySafety During Use PersonnelDescription One-man Sawmill Petrol EngineTools and operator’s manual One-man Sawmill Electric Motor Description Carriage FIG Height Setting FIGFrame and FIG Cleaning Tank FIG Handlebars FIGBand Wheels FIG Bandsaw and Band Guide FIGHeight Adjustment B RailsLog Bolsters a Folding Stops CRail Stop Adjustable Support FeetRail Guard Safety Devices Installation InstallationInstallation Site UnpackingSaw Carriage Setting up the Saw CarriageAssembling the Saw Carriage Saw Carriage Adjustment Band Cleaning Tank FIG Wire adjustment PropulsionPetrol Engine Electric MotorBandsaw Blade Scale FIG Fuel Handling FuelPetrol FuellingStarting and Stopping Starting a Cold Petrol EngineStopping a Petrol Engine Starting a Warm Petrol EngineStarting the Electric Motor Starting the Electric SawmillStopping the Electric Motor USE Securing the LogCalculating the Yield SawingStarting the Petrol Engine Edging Maintenance DismantlingMaintenance Maintenance Band Wheel Adjustment Drive Belt FIGSaw Unit’s Height Adjustment Checking the Braking FunctionMaintenance Daily MaintenanceTechnical Data Petrol EngineEC Declaration of Conformity Only applies to Europe Noise Levels38 ´z+H66¶6R¨ English ´z+H66¶6R¨