Husqvarna SMB 70, SMB 70 E manual Scale FIG

Page 22

INSTALLATION

Scale (FIG 37)

Fit the ruler on the bandsaw blade’s upper guard as follows:

1.Insert the ruler through the top of the scale pointer FIG. 37 A. The greatest value on the ruler shall face downwards.

2.Measure the distance between the underside of the bandsaw blade and the log bolster’s upper section FIG. 38 B. NOTE! During this procedure the bandsaw blade should be tensioned and adjusted.

3.Set the scale so that the scale pointer has the same value and can be read on the scale FIG. 37 C.

4.Bolt the scale to the wheel housing FIG. 37 D.

5.Check that the bandsaw blade moves freely over the long and short log supports when the red mark can be read on the scale pointer. FIG. 37 E

FIG. 37

FIG. 38

22 –English

Image 22

Contents SMB SMB 70 E Table of Contents Introduction IntroductionKEY to Symbols SymbolsSafety Regulations Safety RegulationsPersonal Protective Equipment Safety During Use One-man Sawmill Safety EquipmentFuel Safety PersonnelDescription One-man Sawmill Petrol EngineTools and operator’s manual One-man Sawmill Electric Motor Description Carriage FIG Height Setting FIGFrame and FIG Band Wheels FIG Cleaning Tank FIGHandlebars FIG Bandsaw and Band Guide FIGLog Bolsters a Height Adjustment BRails Folding Stops CRail Stop Adjustable Support FeetRail Guard Safety Devices Installation Site InstallationInstallation UnpackingSaw Carriage Setting up the Saw CarriageAssembling the Saw Carriage Saw Carriage Adjustment Band Cleaning Tank FIG Petrol Engine Wire adjustmentPropulsion Electric MotorBandsaw Blade Scale FIG Petrol Fuel HandlingFuel FuellingStopping a Petrol Engine Starting and StoppingStarting a Cold Petrol Engine Starting a Warm Petrol EngineStarting the Electric Motor Starting the Electric SawmillStopping the Electric Motor USE Securing the LogCalculating the Yield SawingStarting the Petrol Engine Edging Maintenance DismantlingMaintenance Maintenance Band Wheel Adjustment Drive Belt FIGSaw Unit’s Height Adjustment Checking the Braking FunctionMaintenance Daily MaintenanceTechnical Data Petrol EngineEC Declaration of Conformity Only applies to Europe Noise Levels38 ´z+H66¶6R¨ English ´z+H66¶6R¨