STARTING AND STOPPING
Starting the Electric Sawmill
!WARNING!
The sawmill must not be started until the appropriate current and voltage has been connected. Use suitable per- sonnel trained in the country in question.
CAUTION!
The first time the sawmill is started or when it has been moved to another power outlet:
•Test start the sawmill in accordance with the starting instructions.
•Check the direction of the bandsaw blade. If the bandsaw blade runs in the wrong direction, there is a phase inverter on the power connector (FIG. 42). The phase is inverted with the aid of a screwdriver, as illus- trated in FIG. 42.
Starting the Electric Motor
1.Check that the power cable is connected correctly.
2.Set the main switch (35) to 1.
3.Start the motor with the green start button (33). The motor starts.
Stopping the Electric Motor
1.The electric motor is stopped with the raised red button (32).
2.Set the main switch (35) to 0.
FIG. 42
FIG. 43
Starting and Stopping the Bandsaw Blade
The blade is started and stopped using the control handle (4) on the sawmill’s handlebars
(5). Moving the starter handle towards the handlebars activates the clutch and the bandsaw starts. When the control handle is released, the bandsaw blade is braked and stops.
FIG. 44
English – 25