Husqvarna SMB 70, SMB 70 E manual Starting and Stopping, Starting a Cold Petrol Engine

Page 24

STARTING AND STOPPING

!WARNING!

Observe the following before starting the engine:

The engine must be mounted in the sawmill before starting. Otherwise the clutch can come loose and cause personal injuries.

Keep people and animals well away from the risk zone.

Starting a Cold Petrol Engine

A cold engine is started as follows:

1.Open the fuel tap (A).

2.Set the stop switch to the start position (B).

3.Activate the choke. (C)

CAUTION!

Do not pull out the starter cord fully and do not release the starter handle from the fully extended position. This dam- ages the starter.

4.Slowly pull out the starter handle (D) until you feel some resistance (the starter pawls grip). Now pull quickly and firmly.

5.When the engine starts,￿return the choke control.

Stopping a Petrol Engine

The engine is stopped by moving the stop switch

(B) to the stop position. Close the fuel tap (A).

Starting a Warm Petrol Engine

A warm engine is started in the same way as a cold engine, except for the following:

The choke is not used on a warm engine.

Starting instructions can also be found in the Manual for the engine.

Starting and Stopping the Bandsaw Blade

The blade is started and stopped using the control handle (4) on the sawmill’s handlebars

(5). Moving the starter handle towards the handlebars activates the clutch and the bandsaw starts. When the control handle is released, the bandsaw blade is braked and stops.

FIG. 40

FIG. 41

24 – English

Image 24
Contents SMB SMB 70 E Table of Contents Introduction IntroductionKEY to Symbols SymbolsSafety Regulations Safety RegulationsPersonal Protective Equipment One-man Sawmill Safety Equipment Fuel SafetySafety During Use PersonnelDescription One-man Sawmill Petrol EngineTools and operator’s manual One-man Sawmill Electric Motor Description Height Setting FIG Carriage FIGFrame and FIG Cleaning Tank FIG Handlebars FIGBand Wheels FIG Bandsaw and Band Guide FIGHeight Adjustment B RailsLog Bolsters a Folding Stops CAdjustable Support Feet Rail StopRail Guard Safety Devices Installation InstallationInstallation Site UnpackingSetting up the Saw Carriage Saw CarriageAssembling the Saw Carriage Saw Carriage Adjustment Band Cleaning Tank FIG Wire adjustment PropulsionPetrol Engine Electric MotorBandsaw Blade Scale FIG Fuel Handling FuelPetrol FuellingStarting and Stopping Starting a Cold Petrol EngineStopping a Petrol Engine Starting a Warm Petrol EngineStarting the Electric Sawmill Starting the Electric MotorStopping the Electric Motor USE Securing the LogCalculating the Yield SawingStarting the Petrol Engine Edging Maintenance DismantlingMaintenance Maintenance Band Wheel Adjustment Drive Belt FIGSaw Unit’s Height Adjustment Checking the Braking FunctionMaintenance Daily MaintenanceTechnical Data Petrol EngineEC Declaration of Conformity Only applies to Europe Noise Levels38 ´z+H66¶6R¨ English ´z+H66¶6R¨