Husqvarna SMB 70, SMB 70 E manual KEY to Symbols

Page 4

KEY TO SYMBOLS

Symbols

The symbols below are used in this operator’s manual.

Eye protection and hearing protection should be used.

Boots or work shoes with steel toecaps and non-slip soles should

be worn.

Eye protection should be used.

Protective gloves should be worn.

Switch off the engine by moving the stop switch to the STOP position before carry- ing out any checks or mainte- nance.

Warning Signs

The decal with the symbols below is found on the one-man sawmill.

Eye protection and hearing protection should be used.

Protective gloves should be worn.

Boots or work shoes with steel toecaps and non-slip soles should be worn.

Read this manual carefully and make sure you under- stand it before attempting to use the one-man sawmill.

Exercise caution.

Bandsaw blade tension

Bandsaw blade cleaning on tank

Bandsaw start/stop and brake

Height setting

Arrow for bandsaw blade direction

Danger

4 – English

Image 4

Contents SMB SMB 70 E Table of Contents Introduction IntroductionKEY to Symbols SymbolsSafety Regulations Safety RegulationsPersonal Protective Equipment One-man Sawmill Safety Equipment Fuel SafetySafety During Use PersonnelDescription One-man Sawmill Petrol EngineTools and operator’s manual One-man Sawmill Electric Motor Description Carriage FIG Height Setting FIGFrame and FIG Cleaning Tank FIG Handlebars FIGBand Wheels FIG Bandsaw and Band Guide FIGHeight Adjustment B RailsLog Bolsters a Folding Stops CRail Stop Adjustable Support FeetRail Guard Safety Devices Installation InstallationInstallation Site UnpackingSaw Carriage Setting up the Saw CarriageAssembling the Saw Carriage Saw Carriage Adjustment Band Cleaning Tank FIG Wire adjustment PropulsionPetrol Engine Electric MotorBandsaw Blade Scale FIG Fuel Handling FuelPetrol FuellingStarting and Stopping Starting a Cold Petrol EngineStopping a Petrol Engine Starting a Warm Petrol EngineStarting the Electric Motor Starting the Electric SawmillStopping the Electric Motor USE Securing the LogCalculating the Yield SawingStarting the Petrol Engine Edging Maintenance DismantlingMaintenance Maintenance Band Wheel Adjustment Drive Belt FIGSaw Unit’s Height Adjustment Checking the Braking FunctionMaintenance Daily MaintenanceTechnical Data Petrol EngineEC Declaration of Conformity Only applies to Europe Noise Levels38 ´z+H66¶6R¨ English ´z+H66¶6R¨