Husqvarna SMB 70, SMB 70 E manual Fuel Handling, Petrol, Fuelling

Page 23

FUEL HANDLING

Fuel

Fuel Safety

!WARNING!

The fuel used in the one-man sawmill has the following hazardous properties:

1.The fluid, its vapour, and its exhaust fumes are poison- ous.

2.Can cause skin irritation.

3.Is highly inflammable.

The following are absolutely forbidden when fuelling:

•Smoking.

•To have flames or hot objects in close proximity.

•To have the engine running.

Petrol

Use leaded or unleaded petrol. The lowest recommended octane grade is 90. If you run the engine on a lower octane grade than 90, so- called knocking can occur. This leads to an increased engine temperature, which can result in serious engine damage.

Fuelling

1.Clean around the fuel cap.

2.Open the fuel cap slowly so that any excess pressure is released.

3.Tighten the fuel cap carefully after fuelling.

Clean the fuel tank regularly. The fuel filter should be changed at least once a year. Contamination in the fuel tanks causes malfunction.

FIG. 39

English – 23

Image 23

Contents SMB SMB 70 E Table of Contents Introduction IntroductionSymbols KEY to SymbolsPersonal Protective Equipment Safety RegulationsSafety Regulations Personnel One-man Sawmill Safety EquipmentFuel Safety Safety During UseOne-man Sawmill Petrol Engine DescriptionTools and operator’s manual One-man Sawmill Electric Motor Description Frame and FIG Height Setting FIGCarriage FIG Bandsaw and Band Guide FIG Cleaning Tank FIGHandlebars FIG Band Wheels FIGFolding Stops C Height Adjustment BRails Log Bolsters aRail Guard Adjustable Support FeetRail Stop Safety Devices Unpacking InstallationInstallation Installation SiteAssembling the Saw Carriage Setting up the Saw CarriageSaw Carriage Saw Carriage Adjustment Band Cleaning Tank FIG Electric Motor Wire adjustmentPropulsion Petrol EngineBandsaw Blade Scale FIG Fuelling Fuel HandlingFuel PetrolStarting a Warm Petrol Engine Starting and StoppingStarting a Cold Petrol Engine Stopping a Petrol EngineStopping the Electric Motor Starting the Electric SawmillStarting the Electric Motor Securing the Log USESawing Calculating the YieldStarting the Petrol Engine Edging Dismantling MaintenanceMaintenance Maintenance Drive Belt FIG Band Wheel AdjustmentChecking the Braking Function Saw Unit’s Height AdjustmentDaily Maintenance MaintenancePetrol Engine Technical DataNoise Levels EC Declaration of Conformity Only applies to Europe38 ´z+H66¶6R¨ English ´z+H66¶6R¨