Ryobi Complete Guide to CS26 Fuel Mixture and Operation Manual

Page 16

OPERATION

WARNING:

Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury.

WARNING:

Always wear safety goggles or safety glasses with side shields when operating power tools. Failure to do so could result in objects being thrown into your eyes result- ing in possible serious injury.

WARNING:

Do not use any attachments or accessories not recom- mended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury.

FUELING AND REFUELING the trimmer

FUEL MIXTURE

This product is powered by a 2-cycle engine and requires pre-mixing gasoline and 2-cycle lubricant. Pre-mix unleaded gasoline and 2-cycle engine lubricant in a clean 1 gallon container approved for gasoline.

Recommended fuel: This engine is certified to operate on unleaded gasoline intended for automotive use.

Mix a high quality 2-cycle engine lubricant at 2.6 oz. per gallon (US).

Do not use automotive lubricant or 2-cycle outboard

lubricant­ .

DO NOT mix quantities larger than usable in a 30 day period.

high quality 2-cycle engine lubricant

Gasoline

lubricant

 

 

1 gallon (US)

2.6 oz.

1 liter

20 cc (20 ml)

FILLING TANK

Clean surface around fuel cap to prevent contamination.

Loosen fuel cap slowly. Rest the cap on a clean surface.

Carefully pour fuel into the tank. Avoid spillage.

Prior to replacing the fuel cap, clean and inspect the gasket.

Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage.

NOTE: It is normal for smoke to be emitted from a new engine after first use.

WARNING:

Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 30 ft. from refueling site before starting engine. Do not smoke! Failure to heed this warning could result in seri- ous personal injury.

OXYGENATED FUELS

Some conventional gasolines are blended with alcohol or an ether compound. These gasolines are collectively referred to as oxygenated fuels. To meet clean air standards, some areas of the United States and Canada use oxygenated fuels to help reduce emissions.

If using an oxygenated fuel, make sure it is unleaded and meets the minimum octane rating requirements. Before using an oxygenated fuel, try to confirm the fuel’s contents. Some states/provinces require this information to be posted on the pump. The following are the EPA approved percentages of oxygenates:

Ethanol (ethyl or grain alcohol) 10% by volume. You may use gasoline containing up to 10% ethanol by volume. Gasoline containing ethanol may be marketed under the name “Gasohol.” Do not use E85 fuel.

MTBE (methyl tertiary butyl ether) 15% by volume. You may use gasoline containing up to 15% MTBE by volume.

Methanol (methyl or wood alcohol) 5% by volume. You may use gasoline containing up to 5% methanol by volume as long as it also contains cosolvents and corrosion inhibi- tors to protect the fuel system. Gasoline containing more than 5% methanol by volume may cause starting and/or performance problems. It may also damage metal, rubber, and plastic parts of the product or your fuel system.

If you notice any undesirable operating symptoms, try anoth- er service station or switch to another brand of gasoline.

NOTE: Fuel system damage or performance problems re- sulting from the use of an oxygenated fuel containing more than the percentages of oxygenates stated previously are not covered under warranty.

OPERATING THE TRIMMER

See Figure 15.

WARNING:

Always position the unit on the operator’s right side. The use of the unit on the operator’s left side will expose the user to hot surfaces and can result in possible burn injury.

10 — English

Image 16
Contents Save this Manual for Future Reference CS26 RY26500 RY26901Toutes LES Versions Todas LAS VersionesPage CS26 SS26BC26 Bobine À FIL Fixe Dual SpooltmBolt boulon, perno Bonne Position DE Travail Proper Operating PositionDE LA Herramienta Carrete Insert Line through slots until approx Vii Table of Contents General Safety Rules Read all instructionsSpecific safety rules for trimmer use Specific Safety RulesSpecific safety rules for ­ brushcutter and blade use Symbols Symbol NameSymbol Signal Meaning ExplanationFeatures ServiceGrass Deflector TOP-MOUNTED MotorAssembly InstallING the Power Head to the AttachmentRemoving the attachment from the power head UnpackingAttaching the Storage Hanger Attaching the J Handle BC26Installing the Tri-ArcBlade and brushcutter guard Removing the Tri-Arcblade and brushcutter guardConverting from String Trimmer to Brushcutter BC26 Removing the straight shaft grass deflector and String headOperation Fueling and Refueling the trimmerOxygenated Fuels Operating the TrimmerTo Advance the Cutting line bump feed string head Cutting TipsGrass Deflector line Trimming CUT-OFF Blade Operating the BrushcutterTri-ArcBLADE Cutting Technique BladeStarting and Stopping See Figures 21Maintenance General MaintenanceFuel CAP Cleaning the Exhaust Port and Muffler Spark ArrestorStoring the Product Gap. Refer to Spark Plug Replacement earlier TroubleshootingSpeed. See Figure Warranty This product was manufactured with a catalyst mufflerLimited Warranty Statement MANUFACTURER’S Warranty Coverage Règles DE Sécurité Générales Lire Toutes LES InstructionsRègles DE Sécurité Particulières Symbole Nom SymbolesExplication Caractéristiques Installation DU BLOC-MOTEUR SUR L’ACCESSOIRE DéballageListe des pièces AvertissementAssemblage Installation DE LA Bandoulière BC26 Installation DE LA Lame TRI-ARCET DU PARE-DÉBRISConversion DE Débroussailleuse EN TAILLE-BORDURES BC26 Retrait DE LA Lame TRI-ARCET DU PARE- DébrisApprovisionnement EN Carburant UtilisationCarburants Oxygénés Utilisation DU TAILLE-BORDURES Conseils DE CoupeLame DE Sectionnement DE Ligne DE Avertissement Coups DU Déflecteur D’HERBERicochet DE Lame Lame TRI-ARCTechniques DE Coupe Lame Avertissement Démarrage ET ArrêtRemplacement DE LA Bobine Installation de la bobine à fil fixe Dual SpoolEntretien Entretien GénéralREMPLACement de la Bougie Nettoyage DU Filtre À AIR ÉcranRéglage du ralenti Remisage le produitDépannage Garantie ’AIDEÉnoncé DE LA Garantie Limitée Responsabilités DU Propriétaire Dans LE Cadre DE LA Garantie Advertencia Reglas DE Seguridad GeneralesLea todas las instrucciones Reglas DE Seguridad Específicas Símbolos PeligroPrecaución ExplicatiónCaracterísticas Armado DesempaquetadoLista de empaquetado Instalación DEL Cabezal Motor EN EL AditamentoMontaje DE LA ASA DE ALMACENAMIENTO Montaje DEL Deflector DE Pasto AdvertenciaMontaje de la correa para el hombro BC26 Conversión de desbrozadora a recortadora de hilo BC26Conversión de recortadora de hilo a desbrozadora BC26 Vea las figuras 10 yLlenado DEL Tanque FuncionamientoCombustibles Oxigenados Manejo DE LA Recortadora Sugerencias Para CortarCuchilla DE Corte DEL Hilo EN EL Deflector DE Hierba Utilización DE LA DesbrozadoraContragolpe DE LA Cuchilla Cuchilla Tri-ArcTécnica DE Corte CON Cuchilla Advertencia Arranque Y ApagadoMantenimiento Mantenimiento GeneralReemplazo DEL Carrete Vea las figuras 24Parachispas Limpieza DEL Orificio DE Escape Y DEL SilenciadorTapa DEL Tanque DE Combustible Advertencia Solución DE Problemas El motor no arranca No hay chispaGarantía 4050Declaración DE LA Garantía Limitada Cobertura DE LA Garantía DEL Fabricante Page Manuel D’UTILISATION / Manual DEL Operador California PropositionProposition 65 DE L’ÉTAT DE Californie California Propuesta DE LEY NÚM
Related manuals
Manual 48 pages 50.23 Kb

RY26500, CS26, RY26901 specifications

The Ryobi CS26 is a versatile and powerful gas string trimmer designed for homeowners and landscape professionals alike. Featuring a 26cc, 2-cycle engine, the CS26 provides ample power to tackle tough grass and brush, ensuring that your yard work is completed with ease and efficiency. One of its standout features is the Easy Start technology, which significantly reduces the effort required to start the engine. This user-friendly feature allows both seasoned landscapers and newcomers to get the job done without the frustrating pull-start experience.

The CS26 incorporates a lightweight design, weighing in at just around 10 pounds, which enhances maneuverability and reduces operator fatigue during extended use. Its straight shaft design also provides better reach and the ability to navigate around hard-to-reach areas, such as under low-hanging branches or fences.

In terms of cutting capabilities, the Ryobi CS26 is equipped with a durable .095-inch diameter line. This heavy-duty line provides exceptional cutting performance and is designed to withstand the rigors of tough landscaping tasks. The trimmer also features an Easy Reload head, allowing users to quickly and efficiently replace the cutting line without the need for disassembly.

Additionally, the CS26 boasts an adjustable handle that provides comfort and better control while trimming. Users can customize the handle position to fit their preferred working stance, further enhancing the overall user experience. The anti-vibration technology integrated into the design helps to minimize hand fatigue, allowing for longer operation periods without discomfort.

The Ryobi CS26 is not only powerful but also eco-conscious. Its engine design offers lower emissions compared to older models, making it a suitable choice for users who are environmentally aware. The trimmer's capabilities make it ideal for various landscaping tasks, including edging, trimming, and clearing dense brush.

In summary, the Ryobi CS26 gas string trimmer combines power, ease of use, and comfort to create an efficient landscaping tool. With features such as Easy Start technology, a lightweight design, durable cutting line, and adjustable handles, it meets the demands of both homeowners seeking to maintain their lawns and professionals looking for reliable equipment to add to their toolkit. For anyone in search of a dependable string trimmer, the Ryobi CS26 represents an excellent choice that will deliver impressive results.