Ryobi CS26, RY26901, RY26500 manuel dutilisation General Maintenance

Page 19

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage.

WARNING:

Always wear safety goggles or safety glasses with side shields during tool operation. If operation is dusty, also wear a dust mask.

WARNING:

Before inspecting, cleaning, or servicing the machine, shut off engine, wait for all moving parts to stop, and disconnect spark plug wire and move it away from spark plug. Failure to follow these instructions can result in serious personal injury or property damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, lubricant, grease, etc.

installed on the drive shaft. Turn the spool retainer coun- terclockwise to secure.

Slide lines into the housing eyelets and pull outward to rotate the spool into the cutting position.

Push the spool retainer down while pulling on line(s) to manually advance the line and to check for proper as- sembly of the string head.

Installing Line in Bump Feed String Head

See Figures 26 - 28.

Stop the engine and disconnect the spark plug wire. Hold the string head and turn the spool retainer clockwise to remove.

Remove the spool from the string head.

NOTE: Keep the spring attached to the spool. Remove any old line remaining on the spool.

Cut one piece of trimmer line 18 ft. long.

Find the middle of the line section. Loop the line around the hook in the center of the spool. Carefully wind the line in the direction indicated on the top of the spool. Nearing the end of the line, slide one end of the line into each slot of the spool. Do not overfill.

Replace the spool and the spool retainer. Refer to Bump Feed Spool Replacement earlier in this manual.

WARNING:

installing dual spool™ fixed line

Do not at any time let brake fluids, gasoline, petroleum-

string head insert

based products, penetrating lubricants, etc., come in con-

See Figures 29 - 30.

tact with plastic parts. Chemicals can damage, weaken or

Stop the engine and disconnect the spark plug wire.

destroy plastic which may result in serious personal

Remove spool retainer.

injury.

Remove the spool and spring from the string head.

You can often make adjustments and repairs described here.

Find the word LOAD on top of the Dual Spool™ Fixed

For other repairs, have the trimmer serviced by an authorized

Line String Head Insert, then locate the openings on the

service dealer.

sides of the insert beneath LOAD. Place the insert inside

 

bump feed SPOOL REPLACEMENT

the string head so that the openings on the sides of the

See Figures 24 - 25.

insert align with the slots on the sides of the string head.

Make sure the spool is completely seated.

If replacing line only, refer to Installing Line in Bump Feed

Reinstall the spool retainer on the string head and turn

String Head later in this manual.

counterclockwise to secure.

Use only .095 in. diameter trimmer line.

Install line as described in the next section of this

Stop the engine and disconnect the spark plug wire. Hold

manual­

.

the string head and turn the spool retainer clockwise to

installing line in dual spool™ fixed

remove.

Remove the empty spool from the string head. Keep the

line string head insert

spring attached to the spool.

See Figure 30.

Make sure the two lines are captured in the slots opposite

Use monofilament line between .095 in. and .105 in. diam-

each other on the new spool. Make sure the end of each

eter.

 

line is extended approximately 6 in. beyond each slot.

Stop the engine and disconnect the spark plug wire.

Align the slot(s) on the spool to the eyelet(s) on the string

Gather two of the pre-cut lengths of trimmer line provided

head housing. Push down and turn the spool in the nec-

or cut two pieces of trimmer line in 11 in. lengths.

essary direction to align the slot(s).

Insert the lines into the slots located on the sides of the

 

Make sure the string head and the spool retainer are

13 — English

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Todas LAS Versiones Save this Manual for Future ReferenceCS26 RY26500 RY26901 Toutes LES VersionsPage Bobine À FIL Fixe Dual Spooltm CS26SS26 BC26Bolt boulon, perno Bonne Position DE Travail Proper Operating PositionDE LA Herramienta Carrete Insert Line through slots until approx Vii Table of Contents Read all instructions General Safety RulesSpecific safety rules for trimmer use Specific Safety RulesSpecific safety rules for ­ brushcutter and blade use Explanation SymbolsSymbol Name Symbol Signal MeaningTOP-MOUNTED Motor FeaturesService Grass DeflectorUnpacking AssemblyInstallING the Power Head to the Attachment Removing the attachment from the power headAttaching the J Handle BC26 Attaching the Storage HangerRemoving the straight shaft grass deflector and String head Installing the Tri-ArcBlade and brushcutter guardRemoving the Tri-Arcblade and brushcutter guard Converting from String Trimmer to Brushcutter BC26Operating the Trimmer OperationFueling and Refueling the trimmer Oxygenated FuelsOperating the Brushcutter To Advance the Cutting line bump feed string headCutting Tips Grass Deflector line Trimming CUT-OFF BladeSee Figures 21 Tri-ArcBLADECutting Technique Blade Starting and StoppingGeneral Maintenance MaintenanceFuel CAP Cleaning the Exhaust Port and Muffler Spark ArrestorStoring the Product Gap. Refer to Spark Plug Replacement earlier TroubleshootingSpeed. See Figure This product was manufactured with a catalyst muffler WarrantyLimited Warranty Statement MANUFACTURER’S Warranty Coverage Lire Toutes LES Instructions Règles DE Sécurité GénéralesRègles DE Sécurité Particulières Symbole Nom SymbolesExplication Caractéristiques Avertissement Installation DU BLOC-MOTEUR SUR L’ACCESSOIREDéballage Liste des piècesAssemblage Retrait DE LA Lame TRI-ARCET DU PARE- Débris Installation DE LA Bandoulière BC26Installation DE LA Lame TRI-ARCET DU PARE-DÉBRIS Conversion DE Débroussailleuse EN TAILLE-BORDURES BC26Approvisionnement EN Carburant UtilisationCarburants Oxygénés Avertissement Coups DU Déflecteur D’HERBE Utilisation DU TAILLE-BORDURESConseils DE Coupe Lame DE Sectionnement DE Ligne DEDémarrage ET Arrêt Ricochet DE LameLame TRI-ARC Techniques DE Coupe Lame AvertissementEntretien Général Remplacement DE LA BobineInstallation de la bobine à fil fixe Dual Spool EntretienRemisage le produit REMPLACement de la BougieNettoyage DU Filtre À AIR Écran Réglage du ralentiDépannage ’AIDE GarantieÉnoncé DE LA Garantie Limitée Responsabilités DU Propriétaire Dans LE Cadre DE LA Garantie Advertencia Reglas DE Seguridad GeneralesLea todas las instrucciones Reglas DE Seguridad Específicas Explicatión SímbolosPeligro PrecauciónCaracterísticas Instalación DEL Cabezal Motor EN EL Aditamento ArmadoDesempaquetado Lista de empaquetadoMontaje DEL Deflector DE Pasto Advertencia Montaje DE LA ASA DE ALMACENAMIENTOVea las figuras 10 y Montaje de la correa para el hombro BC26Conversión de desbrozadora a recortadora de hilo BC26 Conversión de recortadora de hilo a desbrozadora BC26Llenado DEL Tanque FuncionamientoCombustibles Oxigenados Utilización DE LA Desbrozadora Manejo DE LA RecortadoraSugerencias Para Cortar Cuchilla DE Corte DEL Hilo EN EL Deflector DE HierbaArranque Y Apagado Contragolpe DE LA CuchillaCuchilla Tri-Arc Técnica DE Corte CON Cuchilla AdvertenciaVea las figuras 24 MantenimientoMantenimiento General Reemplazo DEL CarreteParachispas Limpieza DEL Orificio DE Escape Y DEL SilenciadorTapa DEL Tanque DE Combustible Advertencia El motor no arranca No hay chispa Solución DE Problemas4050 GarantíaDeclaración DE LA Garantía Limitada Cobertura DE LA Garantía DEL Fabricante Page California Propuesta DE LEY NÚM Manuel D’UTILISATION / Manual DEL OperadorCalifornia Proposition Proposition 65 DE L’ÉTAT DE Californie
Related manuals
Manual 48 pages 50.23 Kb

RY26500, CS26, RY26901 specifications

The Ryobi CS26 is a versatile and powerful gas string trimmer designed for homeowners and landscape professionals alike. Featuring a 26cc, 2-cycle engine, the CS26 provides ample power to tackle tough grass and brush, ensuring that your yard work is completed with ease and efficiency. One of its standout features is the Easy Start technology, which significantly reduces the effort required to start the engine. This user-friendly feature allows both seasoned landscapers and newcomers to get the job done without the frustrating pull-start experience.

The CS26 incorporates a lightweight design, weighing in at just around 10 pounds, which enhances maneuverability and reduces operator fatigue during extended use. Its straight shaft design also provides better reach and the ability to navigate around hard-to-reach areas, such as under low-hanging branches or fences.

In terms of cutting capabilities, the Ryobi CS26 is equipped with a durable .095-inch diameter line. This heavy-duty line provides exceptional cutting performance and is designed to withstand the rigors of tough landscaping tasks. The trimmer also features an Easy Reload head, allowing users to quickly and efficiently replace the cutting line without the need for disassembly.

Additionally, the CS26 boasts an adjustable handle that provides comfort and better control while trimming. Users can customize the handle position to fit their preferred working stance, further enhancing the overall user experience. The anti-vibration technology integrated into the design helps to minimize hand fatigue, allowing for longer operation periods without discomfort.

The Ryobi CS26 is not only powerful but also eco-conscious. Its engine design offers lower emissions compared to older models, making it a suitable choice for users who are environmentally aware. The trimmer's capabilities make it ideal for various landscaping tasks, including edging, trimming, and clearing dense brush.

In summary, the Ryobi CS26 gas string trimmer combines power, ease of use, and comfort to create an efficient landscaping tool. With features such as Easy Start technology, a lightweight design, durable cutting line, and adjustable handles, it meets the demands of both homeowners seeking to maintain their lawns and professionals looking for reliable equipment to add to their toolkit. For anyone in search of a dependable string trimmer, the Ryobi CS26 represents an excellent choice that will deliver impressive results.
Top Page Image Contents