Black & Decker LST136R Replacement Accessories, CUTTINGYour trimmerLINE /usesLINE Feeding

HELPFUL• CUTTINGTIPSdo not force string headUseintothe uncuttip of grassthe tring. Use toedgedo guidethe cuttialong;such things as fences, houses and flower beds for best practices.

• Wire and picket fences cause extra string wear, even breakage. Stone and brick walls, curbs, and wood may wear string rapidly.

• Do not allow spool cap to drag on ground or other surfaces.

• In long growth cut from the top down and do not exceed 12 inches (304.8 mm) high.

• Keep trimmer tilted toward the area being cut; this is the best cutting area.

• The trimmer cuts when passing the unit from the right to left. This will avoid throwing debris at the operator.

• Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can easily be damaged by the string.

CUTTINGYour trimmerLINE /usesLINE FEEDING

. During .065use, inchthe tips(1.65of themm)nylondiameter,lines willROUNDbecome frayednylon liande worn and the special self feeding spool will automatically feed and trim a fresh length of line.

unit on ground in attempt to feed line or for any otherDOpurposesNOT BUMP. Cutting line will wear faster and require more feeding if the cutting or edging is done along sidewalks or other abrasive surfaces or heavier weeds are being cut.

REPLACEMENT ACCESSORIES

Before you begin trimming, only use the appropriateCAUTION:type of cutting line.

Use Black & Decker replacement spool Model No. AF-100.

• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON MONOFILAMENT LINE. Do not use serrated or heavier gauge line, as they will overload the motor and cause overheating.

• Other replacement parts (guards, spool caps, etc.) are available

through Black & Decker service centers. To find your local service location call: 1-800-544-6986

or visit	P	P2
WARNING: The use of
any accessory not	Replacement
www.blackanddecker.com.
recommended by Black &	spool
Decker for use with this tool	Model #
could be hazardous.	AF-100
REPLACING THE SPOOL
(FIGURES• Remove batteryP,Q ANDfromR) tool.	P1	P1
• Depress the tabs (P1) and		P3
remove the spool cap (P2)
from the spool housing (P3)
in the trimmer head (figure P).
• Replace spool with Black & Decker model # AF-100.
• Grasp empty spool with one hand and spool housing with other
hand and pull spool out.
• If lever (Q1) in base of	Q
housing becomes dislodged,		Q1
replace in correct position
before inserting new spool		Q2
into housing.
• Remove any dirt and grass
from the spool and housing.
• Unfasten the end of the
cuttingline and guide the line
into the eyelet (R2) figure R.
• Take the new spool and
push it onto the boss (Q2) in
the housing. Rotate the spool
slightly until it is seated.
The line should protrude
approximately 4-13/16 inches
(122mm) from the housing.

11