Snapper 1666-0 owner manual Wear protective goggles, rubber apron, and rubber gloves

Page 3

Snapper G1000 Generator

WARNING

Generator produces powerful voltage.

Failure to properly ground generator can result in electrocution.

Failure to isolate generator from power utility can result in death or injury to electric utility workers due to backfeed of electrical energy.

When using generator for backup power, notify utility company. Use approved transfer equipment to isolate generator from electric utility.

National Electric Code requires generator to be properly grounded to an approved earth ground. Call an electrician for local grounding requirements.

Use a ground circuit fault interrupter (GFCI) in any damp or highly conductive area, such as metal decking or steel work.

Do not touch bare wires or receptacles.

Do not use generator with electrical cords which are worn, frayed, bare or otherwise damaged.

Do not operate generator in the rain.

Do not handle generator or electrical cords while standing in water, while barefoot, or while hands or feet are wet.

Do not allow unqualified persons or children to operate or service generator.

WARNING

Running engines produce heat. Temperature of muffler and nearby areas can reach or exceed 150°F (65°C).

Severe burns can occur on contact.

Do not touch hot surfaces.

Allow equipment to cool before touching.

CAUTION

Excessively high operating speeds increase risk of injury and damage to generator.

Excessively low speeds impose a heavy load.

Do not tamper with governed speed. Generator supplies correct rated frequency and voltage when running at governed speed.

Do not modify generator in any way.

CAUTION

Exceeding generators wattage/amperage cappacity can damage generator and/or electrical devices connected to it.

See “Don’t Overload Your Generator” on page 9.

Start generator and let engine stabilize before connecting electrical loads.

Connect electrical loads in OFF position, then turn ON for operation.

Turn electrical loads OFF and disconnect from generator before stopping generator.

DANGER

Storage batteries give off explosive hydrogen gas during recharging.

Hydrogen gas stays around battery for a long time after battery has been charged.

Slightest spark will ignite hydrogen and cause explosion.

You can be blinded or severely injured.

Battery electrolyte fluid contains acid and is extremely caustic.

Contact with battery fluid will cause severe chemical burns.

Do not allow any open flame, spark, heat, or lit cigarette during and for several minutes after charging a battery.

Wear protective goggles, rubber apron, and rubber gloves.

CAUTION

Improper treatment of generator can damage it and shorten its life.

Use generator only for intended uses.

If you have questions about intended use, ask dealer or contact Snapper.

Operate generator only on level surfaces.

Do not expose generator to excessive moisture, dust, dirt, or corrosive vapors.

Do not insert any objects through cooling slots.

If connected devices overheat, turn them off and disconnect them from generator.

Shut off generator if:

-electrical output is lost;

-equipment sparks, smokes, or emits flames; -unit vibrates excessively.

3

Image 3
Contents G1000 Table of Contents Safety RulesEquipment Description Wear protective goggles, rubber apron, and rubber gloves Know Your Generator Engine ON/OFF Switch Used to stop a running engineBefore Starting Engine ContentsGrounding Generator Operating GeneratorStarting the Engine Stopping the Engine Connecting Electrical LoadsCharging a Battery Oil Alert SystemVolt AC Receptacle Connector PlugsVolt DC Accessory Jack Extension CordsExample Power ManagementDont Overload Your Generator CapacityGenerator Specifications Product SpecificationsGeneral Maintenance Recommendations Generator MaintenanceChecking Oil Level Engine MaintenanceTo Clean the Generator Clean/Replace Spark PlugStorage Instructions Service Air CleanerClean Spark Arrester Screen To clean or replace air filter elementOther Storage Tips Long Term Storage InstructionsProblem Cause Correction TroubleshootingWiring Diagram Qty Description Exploded View and Parts List Main UnitCAP, Fuel Cylinder Block, Cylinder Head Qty Description Exploded View and Parts List EngineCrankcase Cover, Crankshaft/Camshaft Qty Description SET, RING, PSTN, STD Piston/Rod, Magneto/Flywheel, Air Cleaner Qty DescriptionCarburetor, Control/Linkages Qty Description Fan Cover, Recoil Starter, Oil Sensor Qty Description Lead Wires, Muffler, Gasket Set Qty Description Instrucciones DE Seguridad Tabla DE ContenidosDescripción DEL Equipo AdvertenciaLos generadores producen un voltaje muy poderoso PrecauciónBujía cubierta del interior Conozca SU GeneradorAñadir Gasolina Contenido DEL EmpaqueAntes DE Darle Arranque AL Generador Añadir Aceite de MotorConexion a Tierra DEL Generador Cómo Utilizar SU GeneradorPara Arrancar el Motor Procedimiento de Carga de la Bateria Conexion de Cargas ElecricasDetener el Motor Aceite Sistema AlertaReceptáculo de 120 Voltios AC Enchufes DE ConexiónCables DE Extensión Clavija Accesoria de 12 Voltios DC, 8.3 AmperiosEjemplo No Sobrecargue EL GeneradorCapacidad Control de la EnergíaEspecificaciones del Generador Especificaciones DEL ProductoRecomendaciones Mantenimiento Generales Mantenimiento DEL GeneradorCambiar el Aceite del Motor Mantenimiento DEL MotorPara Limpiar el Generador Verfique el Nivel de AceiteTransporte y Almacenamiento Instrucciones DEL AlmacenamientoMantenimiento del Filtro de Aire Limpiar el Tamiz Protector Contra ChispasOtros Consejos de Almacenamiento Diagnóstico Y Reparación DE Averías Emission Control System Warranty What is CoveredWhat is Not Covered Que No Esta Cubierto Garantia DEL Sistema DE Control DE EmisionesSus Obligaciones y Derechos de Garantía Que Esta CubiertoGenerac Portable Products, LLC Jefferson, Wisconsin U.S.A Garantía LimitadaNormal wear Snapper Owner Warranty Policy Effective October 1About your equipment warranty Installation and Maintenance