Husky 1800PSI warranty Troubleshooting, Problem or Concern Possible Cause Solution

7.0 TROUBLESHOOTING

PROBLEM OR CONCERN	POSSIBLE CAUSE		SOLUTION
Detergent Leak	Disconnected or Kinked Detergent		Remove the front cover of the unit and check if the
	Pick up Tube		clear tube is still properly attached or kinked. If it is
			not attached then reconnect it or unkink it.
Reservoir Tank won’t hold	Chemical Tank Nipple Broken		The Chemical Tank Nipple is attached to the inside
Detergent			wall of the Reservoir Tank. If it is broken you can
			order a replacement by emailing us at:
			customerservice@huskypowerwasher.com.
Detergent is not dispensing	Incorrect wand is attached to the		Make sure that the Click-N-CleanTMwand is
	Gun		attached to the Gun and set in the “Detergent
			Spray” position Detergent will not dispense with
			the Turbo Wand
	The Click-N-CleanTMwand	is	Turn the shaft of the wand until clicked into the
	not set in the “Detergent Spray”		“Detergent Spray” position (see fig 7 pag. 16).
	position.
	Nozzle is clogged with debris		Straighten out a paper clip and insert it into the tip
			of the Nozzle. Back flush the Nozzle with water.
			(see section 5.2)
Detergent to Water ratio			Adjust the Dial-N-Wash®dial to increase/decrease
			detergent flow. Most power washer chemicals are
			generally concentrated within that range so minimal
			adjustment is required. If you feel like you are using
			more detergent than is required for the application you
			can dilute it with regular tap water. (see section 4.3)
Detergent - What to use			We recommend that you use a cleaner which is
			specifically designed for power washers. There
			are different kinds available depending on the
			application. Check with your local Home Depot
			store for the product which is best suited for your
			needs. Never use Bleach, Ammonia or
			Hot water in the unit.
Detergent Tank fills up with	Detergent Suction Assembly (the		The part will have to be replaced, Please email
water	part which the High Pressure hose		us directly at:
	connects to) is defective		customerservice@huskypowerwasher.com.
			You can also order the part directly at:
			www.huskypowerwasher.com.
Circuit breaker trips or Fuse	Circuit overload		Check that the circuit is rated at 15 amps or
blown in Fuse Box			greater. Make sure the unit is plugged into a
			dedicated circuit.
	Extension cord too long or wire		Use proper extension cord as recommended in
	size too small		Owner’s Manual.
	Nozzle partially blocked		Clean Nozzle as instructed in section 5.2.
	Excessive pressure		Clean Nozzle as instructed in section 5.2
GFCI Plug installation			For GFCI reset procedures see owner’s manual
			section 3.3. For instructions regarding the GFCI
			Plug installation or malfunction please email us
GFCI Plug malfunction			directly at:
			customerservice@huskypowerwasher.com.

23