PROBLEM OR CONCERN | POSSIBLE CAUSE | SOLUTION |
|
|
|
No water coming out of Wand | Detergent Suction Assembly (the | Remove the Gun and Hose assembly from the |
(contd) | part which the High Pressure | front of the unit. Aim water stream away from |
| Hose connects to) is defective | electric source. Turn the faucet on. Water should |
|
| start to come out of the front of the unit. If no |
|
| water comes out, the Detergent Suction Assembly |
|
| will have to be replaced. Contact us at: |
|
| customerservice@huskypowerwasher.com |
|
| or order a replacement directly online at: |
|
| www.huskypowerwasher.com. |
| Gun/Hose Assembly is defective | Attach the Gun/Hose to the front of the unit |
|
| with no wand attached to the Gun. Squeeze the |
|
| trigger of the gun to ensure that water comes |
|
| out of the front of the Gun at a rate equal to the |
|
| Garden Hose. If no water comes out of the Gun |
|
| it will have to be replaced. Contact us at: |
|
| customerservice@huskypowerwasher.com |
|
| or order a replacement directly online at: |
|
| www.huskypowerwasher.com. |
Trigger will not move | Gun Safety Lock in engaged | Release Safety Lock as instructed in Manual. |
|
|
|
Unit will not start | Unit is not turned on | Press ON/OFF Switch into ON position. |
Note: Unit will only start when |
|
|
Loose or disconnected Plug | Reconnect Plug. | |
trigger is depressed. |
|
|
Unit stops while operating | Defective GFCI Plug | Perform GFCI reset procedure as instructed in |
| Section 2.0. If the Plug does not reset it will need | |
|
| to be replaced. Contact us at: |
|
| customerservice@huskypowerwasher.com |
|
| or order a replacement directly online at: |
|
| www.huskypowerwasher.com. |
| Extension Cord length or gauge | Use proper Extension Cord as instructed in section |
| incorrect | 2.0. |
| Gun trigger not operating | Contact us at: |
| properly | customerservice@huskypowerwasher.com |
|
| or order a replacement directly online at: |
|
| www.huskypowerwasher.com. |
| Defective Gun | Remove the Gun and Hose assembly from the front |
|
| of the unit. Aim water stream away from electric |
|
| source and switch the unit into the ON position. |
|
| If the unit starts and water comes out of the front, |
|
| the Gun may need to be replaced. Contact us at: |
|
| customerservice@huskypowerwasher.com |
|
| or order a replacement directly online at: |
|
| www.huskypowerwasher.com. |
| Tripped Pressure washer Thermal | Allow to cool and restart unit. |
| Switch |
|
| Defective ON/OFF Switch | Contact us at: |
|
| customerservice@huskypowerwasher.com |
|
| or order a replacement directly online at: |
|
| www.huskypowerwasher.com. |
Unit will not stop when trigger | Screen filter is clogged | Clean the Screen filter as instructed in the |
is released |
| section 5.4. |
| Garden Hose is kinked or leaking | Make sure the Garden Hose is laid out flat and |
| water | there are no kinks in it. The hose should not be |
|
| wrapped on a storage wheel. Make sure the |
|
| faucet is open all the way and there is a full |
|
| volume of water reaching the unit. |
25