GROUND FAULT CIRCUIT IN- TERRUPTER PROTECTION
This product is supplied with a Ground Fault Circuit Interrupter (GFCI) built into the power cord plug. This device provi- des additional protection from the risk of electric shock. If power is interrupted in the line, the GFCI will automatically re- close the circuit to the load after power is restored. Depending on the GFCI mo- del, it may be necessary to manually operate the reset button to restore po- wer to the GFCI load circuit. If replace- ment of the plug or cord is needed use identical replacement parts.
WATER SUPPLY (Cold Water Only)
CAUTION
Dirt in the feed water will damage the unit. To avoid this risk, we recommend fitting a water filter.
!Water hose must be at least 5/8 inch in diameter.
!Flow rate of water supply must not fall below 2 GPM (gallons per minu- te).
!Flow rate can be determined by run- ning the water for one minute into an empty
!The water supply temperature must not exceed 104°F/40°C.
!Never use the pressure washer to draw in water contaminated with sol- vents, e.g. paint thinners, gasoline, oil, etc.
!Always prevent debris from being drawn into the unit by using a clean water source.
SAVE THESE
INSTRUCTIONS!
"STEP 1:
"STEP 2:
ASSEMBLY INSTRUCTIONS
"STEP 4: Attach the high pressure
hose to the trigger gun.
Pull out the locking slide from the right side of the trigger gun handle (A), and insert the small end of the high pressure hose into place (B).
Push the locking slide back into the trigger gun (C) to lock the hose in po- sition (D).
"STEP 3:
English 5