DeVillbiss Air Power Company A08989, S2600 Troubleshooting Guide, Problem, Cause Correction

Page 17

PROBLEM

Engine will not start (see Engine Manual for further engine troubleshooting)

No or low pressure (initial use)

TROUBLESHOOTING GUIDE

CAUSE

CORRECTION

No fuel.

Add Fuel.

Pressure builds up after two pulls

Squeeze gun trigger to relieve

on the recoil starter or after initial

pressure.

use.

 

Choke lever in the "No Choke"

Move choke lever to the "Choke"

position.

position.

Spark plug wire not attached.

Attach spark plug wire.

Choke lever in the "Choke"

Move choke lever to the "No

position on a "hot" engine or an

Choke" position.

engine that has been exposed to

 

thermal heat for a long period of

 

time.

 

Spray wand not in high pressure.

See How to Use Spray Wand

 

instructions in the Operation

 

Section.

Low water supply.

Leak at high pressure hose fitting.

Nozzle obstructed.

Water filter screen clogged.

Air in hose.

Choke lever in the "Choke" position.

Throttle control lever is not in the "Fast" position.

High pressure hose is too long.

Water supply must be at least 5 GPM @ 20 PSI.

Repair leak. Apply sealant tape if necessary.

See Nozzle Cleaning instructions in the Maintenance section.

Remove and clean filter.

Turn off the engine, then the water supply. Disconnect the water supply from the pump inlet and turn the water supply on

to remove all air from the hose. When there is a steady stream of water present, turn water supply off. Re-connect water supply to pump inlet and turn on water supply. Squeeze trigger to remove remaining air

Move choke lever to the "No Choke" position.

Move throttle control lever to the "Fast" position.

Use high pressure hose under 100'.

17- ENG

A08989

Image 17
Contents Operators Manual Table of ContentsOperation, and Maintenance Instructions Important Safety InstructionsOr serious injury Death or serious injuryRisk to Fluid Injection Risk of Explosion or FireRisk to Breathing Risk of Electrical Shock Risk of Chemical Solution BurnRisk of Injury from Spray Risk of Unsafe OperationAssembly Instructions SpecificationsCarton Contents To Assemble Accessories Panel Basic Elements of a Pressure Washer Operating InstructionsPressure Washer Terminology Pressure AdjustmentsHOW to USE Spray Wand CUT! See a physician immediately Read and Understand ALL Warnings Before Starting UnitDual Detergent Injection System Solution Tips HOW to USE Dual Detergent Injection SystemStarting If applying a cleaning solutionDetergent selection dial Engine Pump Nozzle CleaningReassemble the nozzle to Reconnect wand to gunRemove filter by HOW to Clean the Water Inlet FilterPressure Washer HOW to Drain the DUAL- Detergent Injection TanksCause Correction Troubleshooting GuideProblem Water leaking at pump Pump Pulsates Problem CausecorrectionENG A08989 Gas Powered Pressure Washer Warranty Engine WarrantyTable des matières Guide dutilisationPrécautions À Prendre Risque Dincendie OU Dexplosion CE QUI Peut SE ProduireRisque DE Blessures Corporelles CE QUI Peut SE Produire Risque Dincendie OU Dexplosion suiteRisque Dintoxication PAR Inhalation CE QUI Peut SE Produire Risque DE Brûlures CE QUI Peut SE Produire Risque DE Brûlures Chimiques CE QUI Peut SE ProduireRisque DE Chocs Électriques CE QUI Peut SE Produire Ne bloquez jamais la gâchette en position enfoncée Contenu DE LA Boîte Fiche TechniqueInstructions Dassemblage Sac de piècesPour monter le panneau Utilisation Commande d’étrangleur ouvre etPrincipaux Composants DUN Pulvérisateur Principaux Composants DU MoteurCaractéristiques DU Pulvérisateur TerminologieNE Tentez Jamais Corporelles. Ne dirigez jamais le jet vers des personnesA08989 10- FR Utilisation DU Dispositif D’INJECTION DE Détergent Double De javellisant Pour appliquer des solutions nettoy- antesArrêt DU Pulvérisateur Utilisation DU PulvérisateurCoupez la source d’eau Pompe EntretienMoteur Pump EntreposageNettoyage DE LA Grille DE Filtration À EAU Cadran de sélection de détergent Guide DE Dépannage SolutionProblème Cause PossibleIl y a une fuite à la pompe Problème Cause Possible Solution19- FR A08989 Garantie des pulvérisateurs à essence Garantie du moteur