Briggs & Stratton 20288 manuel dutilisation When Transporting or Repairing Equipment

Page 3

Section 1: Safety Rules

WARNING

Running engine gives off carbon monoxide, an odorless, colorless, poison gas.

Breathing carbon monoxide can cause nausea, fainting or death.

Some chemicals or detergents may be harmful if inhaled or ingested, causing severe nausea, fainting or poisoning.

Operate pressure washer ONLY outdoors.

Keep exhaust gas from entering a confined area through windows, doors, ventilation intakes or other openings.

DO NOT operate pressure washer inside any building or enclosure, even if doors or windows are open.

Use a respirator or mask whenever there is a chance that vapors may be inhaled.

Read all instructions with mask so you are certain the mask will provide the necessary protection against inhaling harmful vapors.

WARNING

Use of pressure washer can create puddles and slippery surfaces.

High pressure spray could cause you to fall if you are too close to the cleaning surface.

Keep spray nozzle between 8 to 24 inches away from cleaning surface.

Operate this unit on a stable surface.

The cleaning area should have adequate slopes and drainage to reduce the possibility of a fall due to slippery surfaces.

Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.

Firmly grasp spray gun with both hands when using high pressure spray to avoid injury when gun kicks back.

WARNING

Fuel and its vapors are extremely flammable and explosive.

Fire or explosion can cause severe burns or death.

WHEN ADDING FUEL

Turn pressure washer OFF and let it cool at least 2 minutes before removing gas cap.

Fill fuel tank outdoors.

DO NOT overfill tank. Allow space for fuel expansion.

If fuel spills, wait until it evaporates before starting engine.

Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition sources.

DO NOT light a cigarette or smoke.

WHEN OPERATING EQUIPMENT

DO NOT tip engine or equipment at angle which causes fuel to spill.

DO NOT spray flammable liquids.

WHEN TRANSPORTING OR REPAIRING EQUIPMENT

Transport/repair with fuel tank EMPTY or with fuel shutoff valve OFF.

WHEN STORING FUEL OR EQUIPMENT WITH FUEL IN TANK

Store away from furnaces, stoves, water heaters, clothes dryers or other appliances that have pilot light or other ignition source because they can ignite fuel vapors.

WARNING

Spray contact with electrical wiring can result in electrocution.

Keep water spray away from electric wiring or fatal electric shock may result.

3

Image 3
Contents Operator’s Manual Manuel d’utilisation Table of Contents Safety RulesEquipment Description When Transporting or Repairing Equipment Unintentional sparking can result in fire or electric shock High pressure spray may damage fragile items including glass Know Your Pressure Washer Section Features and ControlsAssembly Section AssemblyPreparing Pressure Washer for USE Connect Hose and Water Supply to Pump AssemblyChecklist Before Starting Engine Add Engine Oil and FuelPressure Washer Location HOW to USE Your Pressure WasherHow to Start Your Pressure Washer Operation SectionOperation How to Stop Your Pressure WasherTo apply detergent, follow these steps How to Use the Adjustable NozzleApplying Detergent with the Adjustable Nozzle Usage TipsThermal Relief Cleaning Detergent Siphoning TubePressure Washer Rinsing Automatic Cool Down SystemPressure Washer Maintenance Maintenance SectionSpecifications General Maintenance RecommendationsPump Oil Maintenance MaintenanceNozzle Maintenance Ring MaintenanceStoring the Engine Engine MaintenanceStorage Section Preparing the Unit for StorageSection Troubleshooting TroubleshootingProblem Cause Correction Page Page Limited Warranty Règles DE Sécurité Règles de SécuritéTable DES Matières Description DE L ÉquipementLors DE Lajout OU DE LA Vidange DU Carburant Lorsque Vous Réglez OU Réparez Votre Nettoyeur À Pression Règles de Sécurité Connaître Votre Pulvérisateur À Pression Section Fonctions et CommandesAssemblage Section AssemblagePréparation DU Nettoyeur À Pression Pour Utilisation Liste de Vérifications Avant de Démarrer le Moteur AssemblageAjoutez de lhuile et de lessence à moteur Raccorder le Tuyau et la Source Deau à la PompeMettre Votre Nettoyeur à Pression en Marche Emplacement de la Nettoyeur à PressionOpération Section Comment Utiliser Votre Nettoyeur À PressionComment Arrêter Votre Nettoyeur à Pression OpérationAppliquer des Produits Détergents avec le Gicleur Réglable Comment Utiliser les Gicleurs RéglablesTube de siphonnement du détergent Rincer le Nettoyeur à Haute PressionEntretien DU Nettoyeur À Pression Recommandations Générale D’ENTRETIENEntretien Section CaractéristiquesEntretien de la Pompe à Huile EntretienEntretien du Gicleur Entretien du Joint ToriqueEntreposage DU Moteur Rangement SectionEntretien DU Moteur Préparation DE L’UNITÉ Pour L’ENTREPOSAGESection Dépannage DépannageProblème Cause Correction Remarques RemarquesPériode DE Garantie