Briggs & Stratton 20288 Unintentional sparking can result in fire or electric shock

Page 4

Section 1: Safety Rules

WARNING

Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go.

Broken bones, fractures, bruises or sprains could result.

ALWAYS point gun in safe direction and squeeze spray gun trigger, to release pressure and avoid kickback each time, before starting engine. Engage trigger lock when not in use.

When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback.

After each starting attempt, where engine fails to run, always point gun in safe direction and squeeze spray gun trigger to release high pressure.

Firmly grasp spray gun with both hands when using high pressure spray to avoid injury when gun kicks back.

WARNING

Running engines produce heat.Temperature of muffler and nearby areas can reach or exceed 150°F (65°C).

Severe burns can occur on contact.

Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire.

DO NOT touch hot surfaces and avoid hot exhaust gases.

Allow equipment to cool before touching.

Keep at least 5 ft. (152 cm) clearance on all sides of pressure washer including overhead.

Code of Federal Regulation (CFR) Title 36 Parks, Forests, and Public Property require equipment powered by an internal combustion engine to have a spark arrester, maintained in effective working order, complying to USDA Forest service standard 5100-1C or later revision. In the State of California a spark arrester is required under section 4442 of the California Public resources code. Other states may have similar laws.

WARNING

Starter and other rotating parts can entangle hands, hair, clothing, or accessories.

DO NOT wear loose clothing, jewelry or anything that may be caught in the starter or other rotating parts.

Tie up long hair and remove jewelry.

WARNING

The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation.

Spray gun traps high water pressure, even when engine is stopped and water is disconnected, which can cause injury.

NEVER aim spray gun at people, animals or plants.

DO NOT allow CHILDREN to operate pressure washer.

NEVER repair high pressure hose. Replace it.

NEVER repair leaking connections with sealant of any kind. Replace o-ring or seal.

Keep high pressure hose connected to pump and spray gun while system is pressurized.

ALWAYS point gun in safe direction and squeeze spray gun trigger, to release high pressure, every time you stop engine. Engage trigger lock when not in use.

WARNING

High pressure spray can cause paint chips or other particles to become airborne.

Always wear safety goggles when using this equipment or in vicinity of where equipment is in use.

Before starting the pressure washer, be sure you are wearing adequate safety goggles.

WARNING

Unintentional sparking can result in fire or electric shock.

WHEN ADJUSTING OR MAKING REPAIRS TO YOUR PRESSURE WASHER

Disconnect spark plug wire from spark plug and place wire where it cannot contact spark plug.

WHEN TESTING FOR ENGINE SPARK

Use approved spark plug tester.

DO NOT check for spark with spark plug removed.

4

Image 4
Contents Operator’s Manual Manuel d’utilisation Safety Rules Table of ContentsEquipment Description When Transporting or Repairing Equipment Unintentional sparking can result in fire or electric shock High pressure spray may damage fragile items including glass Section Features and Controls Know Your Pressure WasherAssembly Assembly SectionPreparing Pressure Washer for USE Assembly Checklist Before Starting EngineAdd Engine Oil and Fuel Connect Hose and Water Supply to PumpHOW to USE Your Pressure Washer How to Start Your Pressure WasherOperation Section Pressure Washer LocationHow to Stop Your Pressure Washer OperationHow to Use the Adjustable Nozzle Applying Detergent with the Adjustable NozzleUsage Tips To apply detergent, follow these stepsCleaning Detergent Siphoning Tube Pressure Washer RinsingAutomatic Cool Down System Thermal ReliefMaintenance Section SpecificationsGeneral Maintenance Recommendations Pressure Washer MaintenanceMaintenance Nozzle MaintenanceRing Maintenance Pump Oil MaintenanceEngine Maintenance Storage SectionPreparing the Unit for Storage Storing the EngineTroubleshooting Section TroubleshootingProblem Cause Correction Page Page Limited Warranty Règles de Sécurité Table DES MatièresDescription DE L Équipement Règles DE SécuritéLors DE Lajout OU DE LA Vidange DU Carburant Lorsque Vous Réglez OU Réparez Votre Nettoyeur À Pression Règles de Sécurité Section Fonctions et Commandes Connaître Votre Pulvérisateur À PressionAssemblage Assemblage SectionPréparation DU Nettoyeur À Pression Pour Utilisation Assemblage Ajoutez de lhuile et de lessence à moteurRaccorder le Tuyau et la Source Deau à la Pompe Liste de Vérifications Avant de Démarrer le MoteurEmplacement de la Nettoyeur à Pression Opération SectionComment Utiliser Votre Nettoyeur À Pression Mettre Votre Nettoyeur à Pression en MarcheOpération Comment Arrêter Votre Nettoyeur à PressionComment Utiliser les Gicleurs Réglables Appliquer des Produits Détergents avec le Gicleur RéglableRincer le Nettoyeur à Haute Pression Tube de siphonnement du détergentRecommandations Générale D’ENTRETIEN Entretien SectionCaractéristiques Entretien DU Nettoyeur À PressionEntretien Entretien du GicleurEntretien du Joint Torique Entretien de la Pompe à HuileRangement Section Entretien DU MoteurPréparation DE L’UNITÉ Pour L’ENTREPOSAGE Entreposage DU MoteurDépannage Section DépannageProblème Cause Correction Remarques RemarquesPériode DE Garantie

20288 specifications

Briggs & Stratton 20288 is a powerful and efficient portable generator designed to provide reliable backup power for home use, job sites, or outdoor activities. Known for its durable construction and innovative technologies, the model stands out as an ideal choice for consumers looking for both performance and convenience.

One of the main features of the Briggs & Stratton 20288 is its robust engine. Powered by the reliable Briggs & Stratton 306cc engine, this generator delivers a starting wattage of 7000 watts and a running wattage of 5500 watts. This capacity makes it suitable for running multiple appliances simultaneously, including refrigerators, lights, and power tools, making it a valuable asset during power outages or on worksites.

The generator is equipped with an advanced inverter technology, which provides clean, stable power output that is safe for sensitive electronics such as laptops, smartphones, and televisions. This feature ensures that you can confidently use your valuable devices without the risk of damage from voltage fluctuations. Furthermore, the inverter technology also allows for a quieter operation compared to traditional generators, making it ideal for residential areas or camping scenarios.

In addition to its power and technology, the Briggs & Stratton 20288 is built for durability and convenience. Its steel frame construction ensures that it can withstand the rigors of outdoor use while providing stability. The generator also features a foldable handle and never-flat wheels that enhance portability, allowing users to transport it with ease.

The generator includes several user-friendly features, such as an easy-to-read LED display that provides vital information such as remaining run time, power output, and maintenance reminders. The electric start function adds to the convenience, enabling users to start the generator quickly with the push of a button.

Safety is prioritized in the design of the Briggs & Stratton 20288. It is fitted with an automatic low-oil shutdown feature, which protects the engine from damage by stopping operation when oil levels are low. This, combined with a reliable fuel efficiency, ensures that users get optimal performance with minimal operational hassles.

Overall, the Briggs & Stratton 20288 portable generator combines impressive power, advanced technologies, and practical features, making it an excellent choice for individuals seeking a reliable generator that meets a variety of power needs while being easier to transport and operate.