Briggs & Stratton 20341 manual Broken bones, fractures, bruises, or sprains could result

Page 13

8.Rotate fuel shut-off valve to “On” position (A) (fully counter-clockwise).

A

9.Move throttle control lever (B) to “High” position, shown on engine as a rabbit .

B

10. Move choke lever to “Choke position.

NOTE: For a warm engine, be sure the choke lever is in the

Run position.

IMPORTANT: Before starting the pressure washer, be sure you are wearing adequate safety goggles.

WARNING

Risk of eye injury.

Spray can splash back or propel objects.

Always wear safety goggles when using this equipment or in vicinity of where equipment is in use.

Before starting the pressure washer, be sure you are wearing adequate safety goggles.

NEVER substitute safety glasses for safety goggles.

11.When starting engine, position yourself as recommended and grasp starter grip handle and pull slowly until you feel some resistance. Then pull rapidly to start engine.

WARNING

Starter cord kickback (rapid retraction) can result in bodily injury. Kickback will pull hand and arm toward engine faster than you can let go.

Broken bones, fractures, bruises, or sprains could result.

NEVER pull starter cord without first relieving spray gun pressure.

When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback.

After each starting attempt, where engine fails to run, always point spray gun in safe direction, press red button and squeeze spray gun trigger to release high pressure.

Firmly grasp spray gun with both hands when using high pressure spray to avoid injury when spray gun kicks back.

12.Return starter grip handle slowly. DO NOT let rope “snap back” against starter.

13.When engine starts, slowly move choke lever to “Run

position, as engine warms. If engine falters, move choke

lever to “Choke position, then to “Run position.

14.After each starting attempt, where engine fails to run, always point gun in safe direction and press red button

and squeeze spray gun trigger to release high pressure.

Move choke lever to “Choke position, and repeat steps 11 through 13.

15.If engine fails to start after six pulls, move choke lever

to “Run position, and repeat steps 11 through 13.

WARNING

The high pressure stream of water that this equipment produces can cut through skin and its underlying tissues, leading to serious injury and possible amputation.

Spray gun traps high water pressure, even when engine is stopped and water is disconnected, which can cause injury.

DO NOT allow CHILDREN to operate pressure washer.

Keep high pressure hose connected to pump and spray gun while system is pressurized.

NEVER aim spray gun at people, animals, or plants.

DO NOT secure spray gun in open position.

DO NOT leave spray gun unattended while machine is running.

NEVER use a spray gun which does not have a trigger lock or trigger guard in place and in working order.

Always be certain spray gun, nozzles and accessories are correctly attached.

NOTE: Always keep the throttle lever in the “Fast” position when operating the pressure washer.

13

Image 13
Contents Operator’s Manual Pressure Washer Where to Find UsEngine Date PurchasedTable of Contents Safety Rules Operator SafetyHazard Symbols and Meanings Equipment DescriptionOperate pressure washer only outdoors Certain components in this product and relatedContact with muffler area can result in serious burns Broken bones, fractures, bruises, or sprains could resultUnintentional sparking can result in fire or electric shock High pressure spray may damage fragile items including glass Risk of eye injury Spray can splash back or propel objectsAttach Handle and Accessory Tray AssemblyUnpack Pressure Washer Items in the carton includeAdd Fuel Add Engine OilReplace oil fill cap/dipstick and fully tighten Fuel must meet these requirementsConnect Hose and Water Supply to Pump Checklist Before Starting EnginePump Develops high pressure Features and ControlsWater Inlet Connection for garden hose Operation How to Start Your Pressure WasherPressure Washer Location Clearances and Air MovementBroken bones, fractures, bruises, or sprains could result How to Use Accessory Tray How to Stop Your Pressure WasherLow Pressure How to Use Spray TipsHigh Pressure Applying DetergentPressure Washer Rinsing Cleaning Detergent Siphoning TubeAutomatic Cool Down System Thermal Relief For RinsingMaintenance Schedule MaintenancePressure Washer Maintenance Ring Maintenance Engine MaintenanceOil Oil Recommendations To service the air cleaner, follow these steps Service Air CleanerService Spark Plug Checking Oil LevelSpark Arrester Service Install spark plug and tighten firmlyAfter Each Use Air Cooling SystemLong Term Storage Winter StorageProblem Cause Correction TroubleshootingOwner’s Warranty Responsibilities Emissions Control System WarrantyWarranties Emission Information MaintenanceClaims and Coverage Exclusions Limited Warranty Page Common Service Parts Product Specifications800 Manuel d’utilisation Nettoyeur à pression Où nous trouverMoteur Date d’achatSécurité de l’opérateur Fonctions et commandes OpérationAssemblage EntretienSécurité de l’opérateur Symboles de danger et moyensDescription de l équipement Règles de sécuritéCertains composants de ce produit ainsi que les AvertissementLorsque Vous Réglez OU Réparez Votre Nettoyeur À Pression Unintentional peut résulter dans feu ou électriqueAvis Assemblage Fixation de la poignée et du plateau pour accessoiresDéballage du nettoyeur à pression Les articles dans la boîte incluentAjoutez de lessence Ajoutez de lhuile à moteur’essence satisfait les exigences suivantes Altitude élevéeFournissez de leau à une cadence appropriée Liste de vérifications avant de démarrer le moteurFonctions et commandes Opération Emplacement de la nettoyeur à pressionMettre votre nettoyeur à pression en marche Dégagement de la nettoyeur à pression10. Déplacez le levier d’étrangleur à la position « Choke » Comment utiliser les buses Comment utiliser le plateau pour accessoiresBasse Pression Application de détergentHaute Pression Conseils dutilisationTube de siphonnement du détergent Rincer le nettoyeur à pressionPour rincer Calendrier d’entretien EntretienEntretien du nettoyeur à pression Entretien du moteur Huile Recommandations relatives à l’huileEntretien du joint torique Ajout d’huile Vérification du niveau dhuileVidange de lhuile moteur Entretien du filtre à airEntretien du pare-étincelles Entretien de la bougie dallumageSystème de refroidissement à air Entreposage pour lhiver Après chaque utilisationEntreposez le nettoyeur dans un endroit propre et sec Vous devez protéger votre appareil contre le gelEntreposage à long terme Dépannage Garantie du dispositif antipollution GarantiesResponsabilités de la garantie du propriétaire Aucun frais Durée de la couvertureRéclamations et exclusions de couverture EntretienGarantie Limitée Pièces d’entretien courant Caractéristiques du produit