Briggs & Stratton 20341 How to Use Spray Tips, Low Pressure, High Pressure, Applying Detergent

Page 15

How to Use Spray Tips

The quick–connect on the nozzle extension allows you to switch between four different quick connect spray tips. Spray tips can be changed while pressure washer is running once spray gun trigger lock is engaged. The spray tips vary the spray pattern as shown below.

Low Pressure

Black

Use to apply

chemical

High Pressure

40° White

 

15° Yellow

 

0° Red

 

 

 

 

 

 

 

 

 

 

Follow these instructions to change spray tips:

1.Pull back collar on quick–connect and pull current spray tip off. Store spray tips in holes provided in the accessory tray.

WARNING

The high pressure stream of water that this equipment produces can cut through skin and its underlying tissues, leading to serious injury and possible amputation.

•NEVER exchange spray tips without locking the trigger lock on the spray gun.

•DO NOT twist spray tips while spraying.

2. Select desired spray tip:

•For gentle rinse, select white 40° spray tip.

•To scour surface, select yellow 15° or red 0° spray tip.

•To apply detergent, select black spray tip.

3.Pull back on collar, insert new spray tip and release collar. Tug on spray tip to make sure it is securely in place.

Usage Tips

•For most effective cleaning, keep spray tip from 8 to 24 inches (20 to 61 cm) away from cleaning surface.

•If you get spray tip too close, especially using a high pressure spray tip, you may damage surface being cleaned.

•DO NOT get closer than 6 inches (15 cm) when cleaning tires.

Applying Detergent

CAUTION

Chemicals can cause bodily injury, and/or property damage.

•NEVER use caustic liquid with pressure washer.

•Use ONLY pressure washer safe detergents/soaps. Follow all manufacturers instructions.

To apply detergent, follow these steps:

1.Review use of spray tips.

2.Prepare detergent solution as required by job.

3.Place small filter end of detergent siphoning tube into detergent container.

NOTICE

Contact with the hot muffler can damage detergent siphoning tube.

•When inserting the filter into a detergent solution bottle, route the tube so as to keep it from inadvertently contacting the hot muffler.

NOTE: Make sure the filter is fully submerged in detergent while applying detergent.

4. Make sure black spray tip is installed.

NOTE: Detergent cannot be applied with the high pressure spray tips (White, Yellow or Red).

5.Make sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray gun and pump. Turn on water.

NOTICE

You must attach all hoses before you start the engine.

•Starting the engine without all the hoses connected and without the water turned ON will damage the pump.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

6.Start engine following instructions How to Start Your Pressure Washer.

7.Apply detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes.

8.Allow detergent to "soak in" for 3-5 minutes before washing and rinsing. Reapply as needed to prevent surface from drying. DO NOT allow detergent to dry on (prevents streaking).

IMPORTANT: You must flush the detergent siphoning system after each use by placing the filter into a bucket of clean water, then run the pressure washer in low pressure for 1-2 minutes.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Operator’s Manual Date Purchased Where to Find UsPressure Washer EngineTable of Contents Equipment Description Operator SafetySafety Rules Hazard Symbols and MeaningsOperate pressure washer only outdoors Certain components in this product and relatedBroken bones, fractures, bruises, or sprains could result Contact with muffler area can result in serious burnsUnintentional sparking can result in fire or electric shock High pressure spray may damage fragile items including glass Risk of eye injury Spray can splash back or propel objectsItems in the carton include AssemblyAttach Handle and Accessory Tray Unpack Pressure WasherFuel must meet these requirements Add Engine OilAdd Fuel Replace oil fill cap/dipstick and fully tightenConnect Hose and Water Supply to Pump Checklist Before Starting EngineFeatures and Controls Pump Develops high pressureWater Inlet Connection for garden hose Clearances and Air Movement How to Start Your Pressure WasherOperation Pressure Washer LocationBroken bones, fractures, bruises, or sprains could result How to Use Accessory Tray How to Stop Your Pressure WasherApplying Detergent How to Use Spray TipsLow Pressure High PressureFor Rinsing Cleaning Detergent Siphoning TubePressure Washer Rinsing Automatic Cool Down System Thermal ReliefMaintenance Schedule MaintenancePressure Washer Maintenance Engine Maintenance Ring MaintenanceOil Oil Recommendations Checking Oil Level Service Air CleanerTo service the air cleaner, follow these steps Service Spark PlugAir Cooling System Install spark plug and tighten firmlySpark Arrester Service After Each UseLong Term Storage Winter StorageProblem Cause Correction TroubleshootingEmissions Control System Warranty Owner’s Warranty ResponsibilitiesWarranties Maintenance Emission InformationClaims and Coverage Exclusions Limited Warranty Page Product Specifications Common Service Parts800 Manuel d’utilisation Date d’achat Où nous trouverNettoyeur à pression MoteurEntretien Fonctions et commandes OpérationSécurité de l’opérateur AssemblageRègles de sécurité Symboles de danger et moyensSécurité de l’opérateur Description de l équipementCertains composants de ce produit ainsi que les AvertissementLorsque Vous Réglez OU Réparez Votre Nettoyeur À Pression Unintentional peut résulter dans feu ou électriqueAvis Les articles dans la boîte incluent Fixation de la poignée et du plateau pour accessoiresAssemblage Déballage du nettoyeur à pressionAltitude élevée Ajoutez de lhuile à moteurAjoutez de lessence ’essence satisfait les exigences suivantesFournissez de leau à une cadence appropriée Liste de vérifications avant de démarrer le moteurFonctions et commandes Dégagement de la nettoyeur à pression Emplacement de la nettoyeur à pressionOpération Mettre votre nettoyeur à pression en marche10. Déplacez le levier d’étrangleur à la position « Choke » Comment utiliser les buses Comment utiliser le plateau pour accessoiresConseils dutilisation Application de détergentBasse Pression Haute PressionRincer le nettoyeur à pression Tube de siphonnement du détergentPour rincer Calendrier d’entretien EntretienEntretien du nettoyeur à pression Huile Recommandations relatives à l’huile Entretien du moteurEntretien du joint torique Entretien du filtre à air Vérification du niveau dhuileAjout d’huile Vidange de lhuile moteurEntretien de la bougie dallumage Entretien du pare-étincellesSystème de refroidissement à air Vous devez protéger votre appareil contre le gel Après chaque utilisationEntreposage pour lhiver Entreposez le nettoyeur dans un endroit propre et secEntreposage à long terme Dépannage Garanties Garantie du dispositif antipollutionResponsabilités de la garantie du propriétaire Entretien Durée de la couvertureAucun frais Réclamations et exclusions de couvertureGarantie Limitée Pièces d’entretien courant Caractéristiques du produit
Top Page Image Contents