Generac 004373-1, 004626-0 owner manual Add item #42 vinyl trim as shown

Page 42

40 Generac® Power

NOTE:

TORQUE ITEM #6 TO 24 FT/LB AND USE THREAD LOCKING COMPOUND (T-13717).

1To Engine Flywheel

Systems, Inc.

11 5

To Engine

Flywheel Housing

Note:

Thread in Sensor (8) until contact

is made with Ring Gear, then back off 1/2 to 3/4 turn and tighten nut. Caution:

Do not rotate engine during this adjustment.

	9
		13
		12
		14
41		15
40	17	16
	17

22 19

34 32

Add item #42 vinyl trim as shown.

Generator –	(Model Nos.
Drawing No. 0D5333-A	004373-1 & 004626-0)
	Guardian Liquid-cooled
	40 kW Generators

Section 7 — Exploded Views and Parts Lists

Image 42

Contents Power SYSTEMS, INC Introduction Authorized Dealer LocationMaintenance Safety Rules General InformationInstallation Section Installation Drawings 56-57 Warranty Back CoverGeneral Hazards Electrical Hazards Generator AC Connection Systems UNPACKING/INSPECTIONGenerator Automatic System OperationSpecifications Main Circuit BreakerEngine Protective Devices Engine Fuel Requirements RecommendationsGenerator and Load Compatibility Conversion to LP GAS VaporCoolant Emissions Control SystemAIR Fuel Ratio Controller Nfpa Standards Standby Generator InstallationBasic Standby Electric System Other Published StandardsPre-Packaged Type Switch Transfer Switch Start Signal ConnectionsGTS Type Switch Emergency Circuit Isolation MethodBattery Installation Preparation Before START-UPVented Batteries Prior to Initial START-UP Using the AUTO/OFF/MANUAL Switch Automatic Transfer Operation OFF PositionManual Position Sequence of Automatic OperationWeekly Exercise Cycle Checking the Engine OIL LevelChanging the Engine OIL and Filter Oil and Filter Change ProcedureChanging the Engine AIR Cleaner Engine Oil RecommendationsBattery Maintenance Spark PlugsOverload Protection for Engine DC Electrical System Miscellaneous MaintenanceCleaning the Generator DC FuseOUT of Service Procedure Removal From ServiceReturn To Service Service Schedule SYSTEM/COMPONENT Procedure FrequencyTroubleshooting Guide Problem Cause CorrectionElectrical Data Section Power Systems, Inc Generac Power Systems, Inc Electrical Data Electrical Data Electrical Data Wiring Diagram RED Brush Units DPEPanel Face Switch Selector 6A AMP/V Switch Rocker Dpst 125V SPDSwitch TOG Dpdt 15/10 SP Part of Control Panel Wire HarnessGenerators Cover Plate AVR CONTROLLER, B-C #DPG-2103Screen Cover Plate EgovHousing Governor Connect Assembly Motor StepperConnector Interface Assembly Cover Conn HousingPlug Button 3 DIA BASE, Mounting ASSEMBLY, 4.3LAssembly Groundwire 10/3/8 DIRECT-COUPLED4640 31 33 Engine 4.3L GM Switch OIL PressureDC Alternator Assembly Pulley TensionerExploded Views and Parts Lists Wires Spark Plug 4.3L Retainer Plug WiresRetainer Spark Plug Wires Connector C/C VentAdd item #42 vinyl trim as shown Assembly Scroll 390 SAE FAN Assembly 390 SAE DDAssembly Brush & Shunt Carrier Rear BearingShakeproof INT M6 SS Assembly Cover AccessDuct Bottom Duct Front PanelRadiator 14 FIN/INCH Tank Coolant RecoveryBracket Coolant Recovery Tank Venturi 16 DIA 35KWGasket AIR Cleaner Plate AIR Cleanr BottomPlate AIR Cleaner TOP Gasket Carburetor AdaptorHose 1 in ID LP GAS Mixer only Natural GASNPT X Actuator Throttle 42MMNipple Pipe 3/4NPTX4.5 BLK IRN Support Solenoid NAT GASNipple TOE 3/4 NPT X Hose 1IN ID LP GASRegulator N/G R600S LUG Rngtng INSDECAL,INLET Pressure HEATER, Engine 2000W Hose Connection TEEHEATER, Engine 1800W HOSE, Preformed Block HeaterCable Battery Black #1 X Battery 12VDC 90-AH 27F OptionalHold Down Battery Cable Battery RED #1 X11 12 Relay Solenoid 12VDC PNL MNT Cover Lower Connection BOXBushing Snap SB-2.5-31 Transformer 200A to 5A 5VAExploded Views and Parts Lists Mounting Band A-GRP Catalyst Tube Straight a GroupMuffler Catalyst 4.3L Shield Heat Crossover 4.3LMuffler 2-1/2 INLET/OUTLET Clamp Band MufflerGuardian Liquid-cooled 40 kW Generators Installation Drawings 12V Battery see Note Lifting EYE Places Warranty Schedule This Warranty Shall not Apply to the Following