Swim'n Play end deck manual 18’ END Deck, 15’ END Deck, 12’ END Deck

Page 12

7

Before continuing, make sure that all the Posts are perfectly straight and tighten all

 

 

screws and nuts securely. You may now remove the saw horse or patio blocks and allow

 

your deck to rest on the ground.

Attach your assembled deck to your pool as shown.

Remove the ledges where the deck will be assembled.

Move your deck into its final position.

On the 12’ and 15’ End Decks attach the deck ledge to the verticle top plates.

Drill holes on top of the deck aligning with the holes of the top plates and tighten screws supplied for the removed ledges.

If your pool is equipped with full contour style ledge covers, it is necessary to cut them with a hacksaw as illustrated below.

This will enable the deck to mount closer to the pool.

VIEW FROM

ABOVE

PLATES

CUT COVER

18’ END DECK

VIEW FROM

ABOVE

PLATES

CUT COVER

15’ END DECK

VIEW FROM

ABOVE

PLATES

CUT COVER

12’ END DECK

12

Image 12
Contents END Decks General Decks are Made for 52 Inch Deep PoolsAssembly Drawings 15’ END Deck 18’ END Deck CLOSE-UP #3 CLOSE-UP #5CLOSE-UP #4 Bottom Support Channel 12’ END Deck Close UP #7Close UP #10 Close UP #11Close UP #13 Close UP #12CLOSE-UP #15 Location C Location a Close UP #17 Close UP #4Close UP #17 Close UP #11 18’ END Deck 15’ END Deck12’ END Deck Fensurround Instructions General Assembly Illustration Take the Verticals and attach two Fence Post Brackets to Fence Posts as described on the next Standard Post Fence Braket Inserted Through Post Swings on to the deck in the direction