Swim'n Play end deck manual General Assembly Illustration

Page 14

GENERAL ASSEMBLY ILLUSTRATION

Use the General Assembly Illustration below for reference as you assemble the Fensurround.

END POST

STANDARD POST

FENCE BRAKET

OR

INSERTED

CORNER POST

THROUGH POST

9

7¾”

Before assembling your pool, drill the required holes in the Verticals.

Simply place the bracket 7¾” from the top of the Vertical. Then, using the Post Bracket as a template, drill through the Vertical using a 5/16” drill bit.

If your pool is filled with water it will be necessary for you to lower the water level to 2’ deep in order to safely drill these holes and attach the Fence Post Brackets.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents END Decks General Decks are Made for 52 Inch Deep PoolsAssembly Drawings 15’ END Deck 18’ END Deck CLOSE-UP #4 CLOSE-UP #3CLOSE-UP #5 Bottom Support Channel 12’ END Deck Close UP #7Close UP #10 Close UP #11CLOSE-UP #15 Close UP #13Close UP #12 Location C Location a Close UP #17 Close UP #11 Close UP #17Close UP #4 12’ END Deck 18’ END Deck15’ END Deck Fensurround Instructions General Assembly Illustration Take the Verticals and attach two Fence Post Brackets to Fence Posts as described on the next Standard Post Fence Braket Inserted Through Post Swings on to the deck in the direction
Top Page Image Contents