Swim'n Play end deck manual 12’ END Deck, Close UP #7

4a

IMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIME

Where the Posts and the Bottom Support Channels join, attach Angle Support Bars.

The illustrations below indicate Close-up illustrations show the proper assembly procedure for each location.

Where One Angle Support Bar attach to the Post use the ½” Sheet Metal Screws. Where Two Angle Support Bars attach to the Post use the 1” Sheet Metal Screw.

Where the Angle Support Bars attach to the Bottom Support Channels use the ½” Truss Head Screws and Hex Nuts.

Note carefully in the Close-ups the position of the slots in the Angle Support Bars. Again, only hand tighten screws at this time.

CLOSE-UP	CLOSE-UP #7	CLOSE-UP
#7		#7

CLOSE-UP	POST FOR LADDER			15’ END DECK
#8
	ATTACHES ON		&
	EITHER SIDE	CLOSE-UP #7		18’ END DECK
CLOSE-UP #7			CLOSE-UP #7
		POOL
CLOSE-UP		CLOSE-UP #7	CLOSE-UP
#7			#7
#8				12’ END DECK
CLOSE-UP	POST FOR LADDER
	ATTACHES ON	CLOSE-UP #7
	EITHER SIDE
CLOSE-UP #7			CLOSE-UP #7

POOL

CLOSE UP #7

	BOTTOM
ANGLE	OF POST
SUPPORT	1” SHEET METAL
BAR
		SCREW

		CLOSE UP #8
ANGLE		BOTTOM
SUPPORT		SUPPORT
BAR	BOTTOM	CHANNEL
	OF POST

BOTTOM	1/4” x 20	1/4” x 20 x 1/2”	1/2” SHEET	1” SHEET
SUPPORT	HEX NUT	TRUSS HEAD SCREW	METAL SCREW	METAL SCREW
CHANNEL

7