Swim'n Play end deck manual Bottom Support Channel

Page 6

3

IMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIME

Position the Bottom Support Channels (long “L” shaped pieces) at the bottoms of the Posts according to the illustration below for your size deck.

Note the different sizes. (The illustrations are as viewing the deck from above with the Ladder to be installed on the left side.)

73-3/4”73-3/4”

58-7/8”

58-7/8”

58-7/8”

58-7/8”

73-3/4”73-3/4”

POOL

15’ END DECK

&

18’ END DECK

75”

58-7/8”

58-7/8”

58-7/8”

75”

POOL

Having positioned the Bottom Support Channels in their proper locations as illustrated above, attach them to the bottom of the Posts (including the Post for the Ladder) using 1/2” Sheet Metal Screws as shown at right.

73-3/4”

58-7/8”

73-3/4”

BOTTOM SUPPORT

CHANNEL

1/2” SHEET

METAL SCREW

12’ END DECK

1/2” SHEET

METAL SCREW

BOTTOM

OF POST

12’ END DECK

NOTE: On the 12’ End Deck, you must now attach 1 side of remaining 72½” Bottom Support Channel to the outside Posts nearest the pool. See right.

52-5/16

15’ END DECK

66-3/4

18’ END DECK

79-7/16

6

Image 6
Contents END Decks General Decks are Made for 52 Inch Deep PoolsAssembly Drawings 15’ END Deck 18’ END Deck CLOSE-UP #3 CLOSE-UP #5CLOSE-UP #4 Bottom Support Channel 12’ END Deck Close UP #7Close UP #10 Close UP #11Close UP #13 Close UP #12CLOSE-UP #15 Location C Location a Close UP #17 Close UP #4Close UP #17 Close UP #11 18’ END Deck 15’ END Deck12’ END Deck Fensurround Instructions General Assembly Illustration Take the Verticals and attach two Fence Post Brackets to Fence Posts as described on the next Standard Post Fence Braket Inserted Through Post Swings on to the deck in the direction