Swim'n Play end deck manual Assembly Drawings

Page 3

1	Clear out and level the ground in the location where your deck is to be installed.

	Use the Assembly Drawings below for reference while assembling your deck
	(Note: ladder can be installed on either side).
	During assemly please note that the ledges on the pool are to be removed where the
	deck meets the pool. The extension on the front of the deck will replace your pool legde.
	Please refer to Step 7.

LADDER

18’ END DECK

LADDER

ASSEMBLY

DRAWINGS

(VIEWED FROM ABOVE)

15’ END DECK

LADDER

12’ END DECK

3

Image 3

Contents END Decks Decks are Made for 52 Inch Deep Pools GeneralAssembly Drawings 15’ END Deck 18’ END Deck CLOSE-UP #3 CLOSE-UP #5CLOSE-UP #4 Bottom Support Channel Close UP #7 12’ END DeckClose UP #11 Close UP #10Close UP #13 Close UP #12CLOSE-UP #15 Location C Location a Close UP #17 Close UP #4Close UP #17 Close UP #11 18’ END Deck 15’ END Deck12’ END Deck Fensurround Instructions General Assembly Illustration Take the Verticals and attach two Fence Post Brackets to Fence Posts as described on the next Standard Post Fence Braket Inserted Through Post Swings on to the deck in the direction