ViewSonic PJ758/PJ759/PJ760 manual Input Menu, Progressive, Video NR, Color Space, Component

INPUT Menu

INPUT Menu

From the INPUT menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons, and press the ► cursor button or ENTER button to execute the item. Then perform it according to the following table.

Item	Description
	Using the ▲/▼ buttons switches the progress mode.
	TV Ù FILM Ù TURN OFF
	• This function is performed only for an interlaced signal of a video,
PROGRESSIVE	s-video or component video of 525i (480i) or 625i (576i) signal.
	• When TV or FILM is selected, the screen image will be sharp.
	FILM adapts to the 2-3 Pull-Down conversion system. But these
	may cause a certain defect (for example, jagged line) of the picture
	for a quick moving object. In such a case, please select TURN OFF,
	even though the screen image may lose the sharpness.
	Using the ▲/▼ buttons switches the noise reduction mode.
	HIGH Ù MID Ù LOW
VIDEO NR	• This function performs only for a video, s-video or component
	video of 525i(480i) or 625i(576i) signal.
	• When this function is excessive, it may cause a certain
	degradation of the picture.
	Using the ▲/▼ buttons switches the mode for color space.
	AUTO Ù RGB Ù SMPTE240 Ù REC709 Ù REC601
COLOR SPACE	• This item can be selected only for a computer signal or component
	video signal except SCART RGB signal.
	• The AUTO mode automatically selects the optimum mode.
	• The AUTO operation may not work well at some signals. In such a
	case, it might be good to select a suitable mode except AUTO.
	Using the ▲/▼ buttons switches the function of the COMPONENT
	(Y, Cb/Pb, Cr/Pr) port.
COMPONENT	COMPONENT Ù SCART RGB
	When the SCART RGB is selected, COMPONENT (Y, Cb/Pb, Cr/
	Pr) and VIDEO ports will function as a SCART RGB port. A SCART
	cable is required for a SCART RGB input to the projector. For your
	reference, see the TECHNICAL part.

(continued on next page)

ViewSonic 31 PJ758/PJ759/PJ760