Eiki LC-XD25 owner manual Indicators and Projector Condition, Indicators Projector Condition

Appendix

Indicators and Projector Condition

Check the indicators for projector condition.

	Indicators
			Projector Condition
POWER	WARNING	LAMP
		REPLACE
red/green	red	yellow
			The projector is off. (The AC power cord is unplugged.)
			The projector is preparing for stand-by or the projection lamp is

✽being cooled down. The projector cannot be turned on until cooling is completed.

The projector is ready to be turned on with the POWER ON/STAND-

✽BY button.

✽	The projector is operating normally.
✽	The projector is in the Power management mode.
	The temperature inside the projector is abnormally high. The
	projector cannot be turned on. When the projector is cooled
✽	down enough and the temperature returns to normal, the POWER
	indicator lights red and the projector can be turned on. (The
	WARNING indicator keeps blinking.)
	The projector has been cooled down enough and the temperature
✽	returns to normal. When turning on the projector, the WARNING
	indicator stops blinking. Check and clean the air filter.
	The projector detects an abnormal condition and cannot be turned
	on. Unplug the AC power cord and plug it again to turn on the
✽	projector. If the projector is turned off again, disconnect the AC
	power cord and contact the dealer or the service center for service
	and checkup. Do not leave the projector on. It may cause an electric
	shock or a fire hazard.
• • • green	• • • red	• • • off
• • • blinks green	• • • blinks red

✽When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lamp replacement counter after replacing the lamp. See pages 60-62.

69