Video Input
Input Source Selection (S-video, Component, RGB Scart 21-pin)
Direct Operation
Choose
Before using COMPUTER button, correct input source should be selected through Menu operation as described below.
Remote Control
COMPUTER button
COMPUTER button
✔Note:
The operations in the figure are processed when the Input Search function is set to "Off".
✳Computer 2 
RGB(Scart) 
✳Computer 2 
✳
Component 
Computer 2 
✳See Notes at the bottom of this page.
Menu Operation
1 | Press the MENU button to display the |
| Menu. Press the Point 7 8 buttons to move the red |
| framed pointer to the Input Menu icon. |
2 | Press the Point ed buttons to move the red arrow |
| pointer to Computer 1 and then press the SELECT |
| button. |
3 | After the Source Select Menu appeared for Computer |
| 1, move the pointer to |
(Scart) and then press the SELECT button.
Input Menu Input Menu icon
Move the pointer (red arrow) to Computer 1 and press the SELECT button.
Computer
1
Source Select Menu
S-video
Component
RGB (Scart)
When
W h e n t h e i n p u t s o u r c e i s c o m i n g f r o m v i d e o e q u i p m e n t c o n n e c t e d t o t h e C O M P U T E R I N 1 / S - V I D E O I N / C O M P O N E N T I N t e r m i n a l w i t h a C o m p o n e n t - VG A C a b l e , s e l e c t Component.
W h e n t h e i n p u t s o u r c e i s c o m i n g from video equipment connected to the COMPUTER IN 1/S - VIDEO IN/ COMPONENT IN terminal with a Scart- VGA Cable, select RGB (Scart).
M o v e t h e p o i n t e r t o
RGB (Scart) and press the
SELECT button.
✔Notes:
•When the COMPUTER button is pressed while the Input search function is set to "On1" or "On2", the input signal will be searched automatically (p.46)
•When Monitor out is selected in the Terminal function (p.50), Computer 2 is not displayed.
38