Sanyo PDG-DXL100 owner manual Powering Off the Projector

Page 17

Installation

Powering Off the Projector

1.Press the “ON/STAND-BY” to turn off the projector lamp, you will see a message as below on the on-screen display.

2.Press the “ON/STAND-BY” again to confirm.

3.The cooling fan continues to operate for about 60 seconds for cooling cycle and the POWER LED will flash green. When the light starts flashing orange, the projector has entered standby mode.

If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered standby mode. Once in standby mode, simply press “ON/STAND-BY” to restart the projector.

4.Disconnect the power cable from the electrical outlet and the projector.

5.Do not turn on the projector immediately following a power off procedure.

16

English

Image 17

Contents Model PDG-DXL100 Table of Contents Usage Notice PrecautionsRear Do not Introduction Product FeaturesNot Package OverviewProjector Product OverviewControl Panel Connection PortsRefer to the Power On/Off the Pro Remote ControlJector section. See pages 15~16 Confirm your section of items in subImage Volume + Remote Control Operating Range Remote Control Battery InstallationConnect to Computer/Notebook Connecting the ProjectorConnect to Video Lens Cap Power Powering On/Off the ProjectorPowering On the Projector Powering Off the Projector Installation Adjusting the Height of Projector Image Adjusting the Projected ImageAdjusting Projection Image Size Adjusting the Projector FocusOn Screen Display How to operateBrightness Image ModeContrast Total DotsWhite Peaking Fine SyncColor Temp GammaColor Image Video ModeSharpness TintPosition Horizontal Position KeystonePosition Vertical Position Aspect RatioMounting RS232 Mode ECO ModeInput Search Fan ControlRemote Control Eco Standby Power 1WPower Management Closed CaptionFactory Default Lamp Counter ResetSecurity Settings IP Address Network StatusSubnet Mask GatewayInformation LanguageControlling the Projector From Web Configuring the Network SettingClick Use the following IP address, and type in as below User Controls Home How to operate Control Panel Projector Setting Network SettingNetwork Setting Password SettingPJLink Password Setting Security SettingTelnet Password Setting Email Setting Alert SettingSmtp Setting Alert ConditionLogout Problem Partial, scrolling or incorrectly displayed image TroubleshootingProblem No image appears on screen IBM= Problem Image is unstable or flickeringProblem The image is stretched when displaying 169 DVD Problem Image is out of focusProblem Image is reversed Problem Lamp burns out or makes a popping soundPOWER-LED Temp Lamp Problem LED lighting messageProblem Message Reminders Replacing the lamp Lamp Replacing ProcedureOrder Replacement Lamp Air Filters Cleaning Procedure Cleaning the Air FiltersNTSC-M/NTSC-4.43/PAL-B, D, G, H, I/PAL-M/PAL-N/SECAM SpecificationsComputer Compatibility Analog Modes Resolution Frequency KHzComputer Compatibility Digital- Hdmi Modes Resolution Frequency Terminal Mini DIN 8-pin Configurations of TerminalsTerminal Analog RGB Mini D-sub 15 pin FCC notice Regulation & Safety NoticesRemarque à l’intention des utilisateurs cana- diens Operation Serial Control InterfaceFormat Functional Execution CommandStatus Read Command Control Use of TelnetPJLink Notice Lens Center DimensionsKF8A