Sanyo PDG-DXL100 owner manual Regulation & Safety Notices, FCC notice

Page 55

Appendices

Regulation & Safety Notices

This appendix lists the general notices of your Projector.

FCC notice

This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc- tions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be deter- mined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the device and receiv- er.

Connect the device into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Notice: Shielded cables

All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

Caution

Changes or modifications not expressly approved by the manufacturer could void the user’s authority, which is granted by the Federal Communications Commission, to operate this projector.

54

English

Image 55
Contents Model PDG-DXL100 Table of Contents Usage Notice PrecautionsRear Do not Introduction Product FeaturesNot Package OverviewProjector Product OverviewControl Panel Connection PortsConfirm your section of items in sub Remote ControlRefer to the Power On/Off the Pro Jector section. See pages 15~16Image Volume + Remote Control Operating Range Remote Control Battery InstallationConnect to Computer/Notebook Connecting the ProjectorConnect to Video Powering On the Projector Powering On/Off the ProjectorLens Cap Power Powering Off the Projector Installation Adjusting the Height of Projector Image Adjusting the Projected ImageAdjusting Projection Image Size Adjusting the Projector FocusOn Screen Display How to operateTotal Dots Image ModeBrightness ContrastGamma Fine SyncWhite Peaking Color TempColor Image Video ModeSharpness TintAspect Ratio KeystonePosition Horizontal Position Position Vertical PositionMounting Fan Control ECO ModeRS232 Mode Input SearchClosed Caption Eco Standby Power 1WRemote Control Power ManagementSecurity Settings Lamp Counter ResetFactory Default Gateway Network StatusIP Address Subnet MaskInformation LanguageControlling the Projector From Web Configuring the Network SettingClick Use the following IP address, and type in as below User Controls Home How to operate Control Panel Password Setting Network SettingProjector Setting Network SettingTelnet Password Setting Security SettingPJLink Password Setting Alert Condition Alert SettingEmail Setting Smtp SettingLogout Problem No image appears on screen TroubleshootingProblem Partial, scrolling or incorrectly displayed image IBM= Problem Image is unstable or flickeringProblem Lamp burns out or makes a popping sound Problem Image is out of focusProblem The image is stretched when displaying 169 DVD Problem Image is reversedPOWER-LED Temp Lamp Problem LED lighting messageProblem Message Reminders Replacing the lamp Lamp Replacing ProcedureOrder Replacement Lamp Air Filters Cleaning Procedure Cleaning the Air FiltersNTSC-M/NTSC-4.43/PAL-B, D, G, H, I/PAL-M/PAL-N/SECAM SpecificationsComputer Compatibility Analog Modes Resolution Frequency KHzComputer Compatibility Digital- Hdmi Modes Resolution Frequency Terminal Analog RGB Mini D-sub 15 pin Configurations of TerminalsTerminal Mini DIN 8-pin FCC notice Regulation & Safety NoticesRemarque à l’intention des utilisateurs cana- diens Operation Serial Control InterfaceFormat Functional Execution CommandStatus Read Command Control Use of TelnetPJLink Notice Lens Center DimensionsKF8A