Sanyo PDG-DXL100 Powering On/Off the Projector, Powering On the Projector, Lens Cap Power

Page 16

Installation

Powering On/Off the Projector

Powering On the Projector

1.Ensure that the power cable and signal cable are securely connected. The POWER LED will turn orange.

2.Remove the lens cap. 

3.Turn on the lamp by pressing “ON/STAND-BY” on the control panel.  The POWER LED will now flash green.

The startup screen will display in approximately 5 seconds.

When disappear startup screen, the POWER LED will turn green.

4.Turn on your source (computer, notebook, video player, etc.) The projector will detect your source automatically.

If you connect multiple sources at the same time, use the

“INPUT” on the remote control or use “COMPUTER 1”,

“COMPUTER 2”, “S-VIDEO”, “VIDEO”, “HDMI” on the remote control to switch inputs.

Note

Turn on the projector first and then the signal sources.

1	2
Lens Cap	Power

15

English

English

Image 16

Contents Model PDG-DXL100 Table of Contents Precautions Usage NoticeRear Do not Product Features IntroductionPackage Overview NotProduct Overview ProjectorConnection Ports Control PanelRemote Control Refer to the Power On/Off the ProJector section. See pages 15~16 Confirm your section of items in subImage Volume + Remote Control Battery Installation Remote Control Operating RangeConnecting the Projector Connect to Computer/NotebookConnect to Video Powering On the Projector Powering On/Off the ProjectorLens Cap Power Powering Off the Projector Installation Adjusting the Projected Image Adjusting the Height of Projector ImageAdjusting the Projector Focus Adjusting Projection Image SizeHow to operate On Screen DisplayImage Mode BrightnessContrast Total DotsFine Sync White PeakingColor Temp GammaImage Video Mode ColorTint SharpnessKeystone Position Horizontal PositionPosition Vertical Position Aspect RatioMounting ECO Mode RS232 ModeInput Search Fan ControlEco Standby Power 1W Remote ControlPower Management Closed CaptionSecurity Settings Lamp Counter ResetFactory Default Network Status IP AddressSubnet Mask GatewayLanguage InformationConfiguring the Network Setting Controlling the Projector From WebClick Use the following IP address, and type in as below User Controls Home How to operate Control Panel Network Setting Projector SettingNetwork Setting Password SettingTelnet Password Setting Security SettingPJLink Password Setting Alert Setting Email SettingSmtp Setting Alert ConditionLogout Problem No image appears on screen TroubleshootingProblem Partial, scrolling or incorrectly displayed image Problem Image is unstable or flickering IBM=Problem Image is out of focus Problem The image is stretched when displaying 169 DVDProblem Image is reversed Problem Lamp burns out or makes a popping soundProblem LED lighting message POWER-LED Temp LampProblem Message Reminders Lamp Replacing Procedure Replacing the lampOrder Replacement Lamp Cleaning the Air Filters Air Filters Cleaning ProcedureSpecifications NTSC-M/NTSC-4.43/PAL-B, D, G, H, I/PAL-M/PAL-N/SECAMModes Resolution Frequency KHz Computer Compatibility AnalogComputer Compatibility Digital- Hdmi Modes Resolution Frequency Terminal Analog RGB Mini D-sub 15 pin Configurations of TerminalsTerminal Mini DIN 8-pin Regulation & Safety Notices FCC noticeRemarque à l’intention des utilisateurs cana- diens Serial Control Interface OperationFunctional Execution Command FormatStatus Read Command Use of Telnet ControlPJLink Notice Dimensions Lens CenterKF8A