Appendices
Replacing the lamp
Warning: To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp!
The projector will detect the lamp life itself. It will show you a warning message
When you see this message, change the lamp as soon as pos- sible. Make sure the projector has been cooled down for at least 60 minutes before changing the lamp.
1
2
3
4
Lamp Replacing Procedure:
Warning: To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if it is dropped.
1.Switch off the power to the projector by pressing the “ON/
2.Allow the projector to cool down at least 60 minutes.
3.Disconnect the power cable.
4.Use a screwdriver to remove the 2 screws from the cover.
5.Push up and remove the cover.
6.Remove the 2 screws from the lamp module and pull up the lamp bar.
7.Pull out the lamp module by force.
Warning: For contin- ued safety replace with a lamp of the same type.
8.Install the new lamp module by reversing the previous steps.
9.After replacing the lamp, turn on the power, and select the menu
46
English