Sanyo PDG-DXL100 owner manual Problem LED lighting message, POWER-LED Temp Lamp

Page 45

Appendices

Problem: LED lighting message

		POWER-LED			TEMP-	LAMP-
Message		POWER-LED			LED	LED
Message					LED	LED
	(Red)		(Green)	(Orange)	(Red)	(Red)

Standby (Input power cable)

Normal (Power on)

Powering up (Warming up)

Flashing

Power off (Cooling-I: It can’t accept any		Flashing
key at this status)		Flashing
key at this status)

Power off (Cooling-II: It can accept			Flashing
power key to turn on the projector)			Flashing
power key to turn on the projector)

Error (Lamp failed)	*

Error (Fan lock)	Flashing
Error (Over temp.)

Note

Steady light => No light =>

*=> When LED light

on after 5 sec., go to

standby mode.

44

English

Image 45

Contents Model PDG-DXL100 Table of Contents Usage Notice PrecautionsRear Do not Introduction Product FeaturesNot Package OverviewProjector Product OverviewControl Panel Connection PortsRefer to the Power On/Off the Pro Remote ControlJector section. See pages 15~16 Confirm your section of items in subImage Volume + Remote Control Operating Range Remote Control Battery InstallationConnect to Computer/Notebook Connecting the ProjectorConnect to Video Powering On/Off the Projector Powering On the ProjectorLens Cap Power Powering Off the Projector Installation Adjusting the Height of Projector Image Adjusting the Projected ImageAdjusting Projection Image Size Adjusting the Projector FocusOn Screen Display How to operateBrightness Image ModeContrast Total DotsWhite Peaking Fine SyncColor Temp GammaColor Image Video ModeSharpness TintPosition Horizontal Position KeystonePosition Vertical Position Aspect RatioMounting RS232 Mode ECO ModeInput Search Fan ControlRemote Control Eco Standby Power 1WPower Management Closed CaptionLamp Counter Reset Security SettingsFactory Default IP Address Network StatusSubnet Mask GatewayInformation LanguageControlling the Projector From Web Configuring the Network SettingClick Use the following IP address, and type in as below User Controls Home How to operate Control Panel Projector Setting Network SettingNetwork Setting Password SettingSecurity Setting Telnet Password SettingPJLink Password Setting Email Setting Alert SettingSmtp Setting Alert ConditionLogout Troubleshooting Problem No image appears on screenProblem Partial, scrolling or incorrectly displayed image IBM= Problem Image is unstable or flickeringProblem The image is stretched when displaying 169 DVD Problem Image is out of focusProblem Image is reversed Problem Lamp burns out or makes a popping soundPOWER-LED Temp Lamp Problem LED lighting messageProblem Message Reminders Replacing the lamp Lamp Replacing ProcedureOrder Replacement Lamp Air Filters Cleaning Procedure Cleaning the Air FiltersNTSC-M/NTSC-4.43/PAL-B, D, G, H, I/PAL-M/PAL-N/SECAM SpecificationsComputer Compatibility Analog Modes Resolution Frequency KHzComputer Compatibility Digital- Hdmi Modes Resolution Frequency Configurations of Terminals Terminal Analog RGB Mini D-sub 15 pinTerminal Mini DIN 8-pin FCC notice Regulation & Safety NoticesRemarque à l’intention des utilisateurs cana- diens Operation Serial Control InterfaceFormat Functional Execution CommandStatus Read Command Control Use of TelnetPJLink Notice Lens Center DimensionsKF8A