Sanyo PLC-WXU300K owner manual Part Names and Functions, ⑤ LAN Connection Terminal

Part Names and Functions

Rear Terminal

			③	④	⑤
*	①	②

①CONTROL PORT

When the projector is controlled by a computer, connect to this jack with serial control cable.

②COMPUTER IN 1 / COMPONENT IN

Connect output signal from a computer, RGB scart 21-pin video output or component video output to this terminal (pp.14,16).

③COMPUTER IN 2 / MONITOR OUT

–Connect computer output to this terminal (p.14).

–This terminal can be used to output the incoming analog RGB signal from COMPUTER IN 1/ COMPONENT IN terminal to the other monitor (p.14).

④HDMI

Connect the HDMI signal (including sound signal) from video equipment or the DVI signal from computer to this terminal (pp.14, 16).

⑤LAN Connection Terminal

Connect the LAN cable (refer to the owner’s manual of "Network Set-up and Operation").

⑥S-VIDEO IN

⑩ ⑨ ⑧ ⑦ ⑥

⑦AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack (pp.14-16).

This terminal outputs sound from AUDIO IN terminal (⑧ or ⑨).

⑧COMPUTER 1 / COMPUTER 2 AUDIO IN

Connect the audio output (stereo) from a computer or video equipment connected to ② or ③ to this jack. (pp14, 16)

⑨AUDIO IN

Connect the audio output signal from video equipment connected to ⑥ or ⑩ to this jack. For a mono audio signal (a single audio jack), connect it to the L (MONO) jack (p.15).

⑩VIDEO IN

Connect the composite video output signal to this jack (p.15).

* is registered trademarks of HDMI Licensing, LLC.

Connect the S-VIDEO output signal from video equipment to this jack (p.15).