Sanyo PLC-WXU300K owner manual Standby mode, Power management

Setting

Standby mode

This function is available when operating the projector via network.

Network..... Supply the power to the network function even

after turning off the projector. You can turn on/ off the projector via network, modify network environment, and receive an e-mail about projector status while the projector is powered off.

Eco............. Select Eco when you do not use the projector

via network. The projector’s network function will stop when turning off the projector.

Refer to the owner’s manual of “Network Set-up and Operation”.

Note:

•Factory default is Eco.

•When selecting Network, the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.

Select one of the following options:

Ready	When the lamp has been fully cooled
	down, the POWER indicator changes
	to green blinking. In this condition, the
	projection lamp will be turned on if the
	input signal is reconnected or any button
	on the top control or remote control is
Shut down	pressed.
	When the lamp has been fully cooled
Off	down, the power will be turned off.
	Power management function is off.
Timer	If the input signal is interrupted and
	no button is pressed for more than
	30 seconds, the timer display with No
	signal appears. It starts the countdown
	until the lamp is turned off. Use the Point
	▲▼ buttons to set the Timer(1~30min).

Note:

Factory default is Ready: 5 min.

Power management

Timer left before Lamp is off.

52